Maintenance
■BLADES
•When refilling the tank or resting, it is often a good idea to use the time to oil the cutting blades.
•If a gap exists between the upper and lower blades, follow the procedure below to adjust them so that they fit more closely together.
1.Loosen lock nut (A) as shown in the diagram.
2.Tighten screw (B) fully, and then turn
3.While holding onto the screw to keep it in position, tighten the lock nut.
4.Check to make sure that the flat washer
(C)is loose enough so that it may be turned by pressing on it with a finger.
NOTE
Screwing in the screw too tightly may make it impossible for the blades to move. Conversely, not screwing in the screw tightly enough may make the blades of the trimmer feel dull and cause leaves and branches to become caught in the blades of the trimmer.
QUICK TIP
If the blades become so worn down that it is no longer possible to eliminate the gap between them, you should contact the authorized RedMax servicing dealer from which you purchased your RedMax® trimmer to have the blades resharpened or replaced.
■GEAR CASE
The inside of the gear case should be lubricant using
When adding lubricant, use a grease gun to insert lubricant into the three grease nipples located on the gear case.
TYPE OF LUBRICANT TO BE USED
Always be sure to use #2 lithium
14