6. Set up
5.Tighten the mounting nut securely with the bar tip held up (TORQUE: 8.9 - 11.7 N.m./90 - 120
(1) Tighten
WARNING
Itisveryimportanttomaintaintheproperchaintension.Rapid wear of the guide bar or the chain coming off easily can be caused by improper tension. Especially when using a new chain, take good care of it since it should expand when first used.
HARNESS
WARNING
ALWAYS WEAR THE PROVIDED HARNESS WHEN USING THE MACHINE!
Always make sure the machine is hooked securely to the harness.
If you don’t, you will be unable to control the machine safely. This can result in injury to yourself or others.
Never use a harness with a defective quick release or any other damage.
HOW TO WEAR
1. Wear the provided harness without twisted bands, with the hanger on your right side.
(1)
(1) Hanger
(Single strap)
BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
QUICK RELEASE
The harness is equipped with a “QUICK RELEASE” devise. To release the machine from the harness in emergency situa- tions, please follow the procedure as explained below.
WARNING
Make sure to check proper working of the QUICK RELEASE device BEFORE operating the machine.
Make sure to hold the unit securely when using the QUICK RELEASE.
While holding the unit by your right hand securely, press both sides of the buckle.
(1)
(1) Buckle
(Single strap)
PSZ2610
7. Fuel and chain oil
■FUEL
WARNING
• Gasoline is very flammable. Avoid smoking or | G |
bringing any flame or sparks near fuel. Make sure | |
to stop the engine and allow it cool before refuel- | B |
ing the unit. Select outdoor bare ground for fueling |
|
and move at least 3 m (10 ft) away from the fueling |
|
point before starting the engine. |
|
•The Zenoah engines are lubricated by oil specially formulated for
•Do not use BIA or TCW
■RECOMMENDED MIXING RATIO
GASOLINE 50 : OIL 1
(when using ZENOAH genuine oil)
•Exhaust emission are controlled by the funda- mental engine parameters and components (eq., carburation, ignition timing and port timing) with- out addition of any major hardware or the introduc- tion of an inert material during combustion.
•These engines are certified to operate on unleaded gasoline.
•Make sure to use gasoline with a minimum octane number of 89RON (USA/Canada: 87AL).
•If you use a gasoline of a lower octane value than pre- scribed, there is a danger that the engine tempera- ture may rise and an engine problem such as piston seizing may consequently occur.
•Unleaded gasoline is recommended to reduce the con- tamination of the air for the sake of your health and the environment.
•Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine.
■HOW TO MIX FUEL
WARNING
•Pay attention to agitation.
1.Measure out the quantities of gasoline and oil to be mixed.
2.Put some of the gasoline into a clean, approved fuel container.
3.Pour in all of the oil and agitate well.
4.Pour in the rest of gasoline and agitate again for at least one minute. As some oils may be difficult to agitate de- pending on oil ingredients, sufficient agitation is neces-