Zenoah EB7001 Operation, Starting Engine, Adjusting Idle Speed, Stopping Engine, Ignition Switch

EB7001

8. Operation

STARTING ENGINE

IMPORTANT

•Avoid operating the blower with the flexible tube and swivel joint disconnected.That will reduce the cool- ing air and the engine could be damaged by over- heating.

1.Push the primer bulb until fuel flows out in the clear tube.

2.When the engine is cool, close the choke.

6.Once the engine is running, gradually open the choke if it was set closed, and let the engine run at idle speed for a minute to warm it up.

NOTE

When the engine fails to start after several attempts due to overchoking, open the choke and repeat pulling the rope.

ADJUSTING IDLE SPEED

•The idling speed is set for 2000 rpm at the factory. If it is necessary to adjust the idle speed, use the adjust- ment screw on the top side of carburetor.

(1

(1)	Choke Lever	(2) Primer Bulb
(3)	OPEN	(4) CLOSE

3. Set the ignition switch to the start position.

(1)	Full Throttle
(2)	About 1/3 Open	(1)
(3) Idling

(2)

(3)

(1) Idling Adjustment Screw

STOPPING ENGINE

•Move the throttle lever to the idling position and set the ignition switch to the stop position.

(1) Ignition Switch (1)

4.Set the throttle lever in 1/3 open position.

5.To start, hold the top of the blower firmly with your left hand. Pull the starter knob slowly until you feel it en- gage and then give it a vigorous strong pull.

IMPORTANT

•Avoid pulling the starter rope out to its full extent and allowing the starter rope to snap back.This will prevent premature damage to the starter.

•Do not let a person stand near the blower or the exhaust port.

NOTE

If the engine won’t stop when setting the ignition switch to the stop position, close the choke lever and stop the engine.

In this case, please repair the machine at your nealest servicing dealer.

(1) Choke Lever

(2) Primer Bulb

(3) OPEN

(4) CLOSE

GB-10