8. Operation
ADJUSTING THROTTLE CABLE
•The normal play is 1 or 2 mm when measured at the carburetor side end. Readjust with the cable adjuster as required.
| |
(.04 in) | (1) |
(1) Cable adjuster
ADJUSTING IDLING SPEED
(1)
(1)Idle speed adjuster
1.When the engine tends to stop frequently at idling mode, turn the adjusting screw clockwise.
2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw
NOTE
• Warm up the engine before adjusting the idling speed.
CUTTER APPLICATION CHART
•Replace by a suitable recommended cutting attach- ment according to the object to be cut.
•When replacing blade always be sure to use products which have been certified by ZENOAH.
WARNING
•When sharpening, removing, or reattaching the blade, be sure to wear thick, sturdy gloves and use only proper tools and equipment to prevent injury.
BCZ3200DL / BCZ3200DW
METAL BLADE USAGE
1.Check the nut to fasten the blade and be sure the nut has no fault, and no abrasion.
2.Be sure that the blade and the holder have been fas- tened according to instruction and the blade turns smoothly without abnormal noise.
WARNING
•The rotating parts fastened incorrectly may cause serious accident to the operator.
•Make sure that the blade is not bent, warped, cracked, broken or damaged.
•If you find any error to the blade, discard it and change new one which is certified by
ZENOAH.
•By using the shoulder strap, hang the unit on your right side. Adjust the strap length so that the cutting head may become parallel to the ground.
WARNING
•Make sure to use shoulder strap and cut- ting attachment guard. If not, it is vary dan- gerous when you slip or lose your balance.
G B