G6200
A log lying on the ground
Saw down halfway, then roll the log over and cut from the opposite side.
A log hanging off the ground
In area A, saw up from the bottom
Cutting the limbs of Fallen Tree
7. Maintenance
First check to which side the limb is bent. Then make the initial cut from the bent side and finish by sawing from the opposite side.
WARNING
•Be alert to the springing back of a cut limb. Pruning of Standing Tree
Cut up from the bottom, finish down from the top.
WARNING
•Do not use an unstable foothold or ladder.
•Do not overreach.
•Do not cut above shoulder height.
•Always use both your hands to hold the saw.
WARNING
2. Oiling port
Dismount the guide bar and check the oiling port for clogging.
•Before cleaning, the inspecting or repairing the unit, make sure that engine has stopped and is cool. Dis- connect the spark plug to prevent accidental starting.
■MAINTENANCE AFTER EACH USE 1. Air filter
Loosen the knob and remove the air cleaner cover. Take off the filter element and brush off attached sawdust. When the filter is clogged with dust, separate it in halves and
(1)Air filter
Oiling port
3. Guide bar
When the guide bar is dismounted, remove sawdust in the bar groove and the oiling port.
Grease the nose sprocket from the feeding port on the tip of the bar.
Grease port
Sprocket
Oiling port
NOTE
•When servicing the air filter, be sure to block the air intake hole with cloth.
4. Others
Check for fuel leakage and loose fastenings and damage to major parts, especially handle joints and guide bar mounting. If any defects are found, make sure to have them repaired before operating the saw again.