G3300 / G3300EZ
5. Operating the Engine
It is very dangerous to run a chainsaw that mounts broken parts or lacks any parts. Before starting engine, make sure that all the parts including bar and chain are installed properly.
■STARTING THE ENGINE
1.Fill fuel and chain oil tanks respectively, and tighten the caps securely.
(1)
(2) | (1) | Fuel |
| (2) | Chain oil |
2.Set the switch to “I” position.
(1)
(1) Switch
3.Continuously push the priming bulb until fuel comes in the bulb.
(1)
(1) Priming bulb
4.Pull out the choke knob completely to close the choke.
(1)
(1) Choke knob
(2) Close
(3) Open
(2)(3)
NOTE: When restarting immediately after stopping the engine, you need not to pull out the choke knob.
5.While holding the saw unit securely on the ground, pull the starter rope vigorously.
G |
B |
Do not start the engine while the chain saw hangs in one hand. The saw chain may touch your body. This is very dangerous.
6.When engine has ignited, pull the throttle slightly to return the choke knob to the original position. If the engine stops, pull the starter again without pulling out the choke knob.
7.Allow the engine to warm up with the throttle lever pulled slightly.
Keep clear of the saw chain as it will start rotatIng upon starting of engine.
■CHECKING THE OIL SUPPLY
Make sure to set up the bar and the chain when checking the oil supply.
If not, the rotating parts may be exposed. It is very dangerous.
After starting the engine, run the chain at medium speed and see if chain oil is scattered off as shown in the fig- ure.
(1) Chain oil
The chain oil flow can be changed by inserting a screwdriver in the hole on bottom of the clutch side. Adjust according to your work conditions.
(1) Rich
(2) Lean
(3) Chain oil flow adjusting
■ADJUSTING THE CARBURETOR
(1) | (3) | (2) |
(1) L needle
(2) H needle
(3) Idle adjusting screw