F1
F2
F3
F4
English
5. OPERATION
■ STARTING THE ENGINE
WARNING
Keep the blades clear of everything around It as they will start moving upon the engine starts.
1. [eHT753S] Make sure that the throttle lever is at idling position. [eHT603D] Release the throttle lever and make sure it is fully back. (F1)
2. [eHT603D] Set the engine switch to the “I (RUN)” position. (F1)
3. Push the primer pump until overflown fuel flows out in the clear tube. (F2)
4. Move the choke lever to the closed position. (F3)
(1) | Throttle lever | (7) | Stop | |
(2) | Full throttle | (8) | Primer pump | |
(3) | Idling (start position) | (9) | Clear tube | |
(4) | Stop switch | (10) | Choke lever | |
(5) | Engine switch | (11) | Open | |
(6) | Run | (12) | Close | |
5. Place the unit on a flat, firm place. Keep the cutting head clear of everything around it.
6. While holding the unit firmly, pull out the starter rope quickly. (F4)
7. After the engine has started, allow the engine to warm up. Pull the throttle lever.
■ STOPPING THE ENGINE (F1)
[eHT753S]
1. Please return the throttle lever completely.
2. Press the stop switch until the engine comes to a complete stop.
[eHT603D]
1. Release the throttle lever.
2. Move the engine switch to the “O(STOP)”position.
NOTE
If the engine doesn’t stop after stopping the switch, close the choke so that engine will stop after a little.
13