Poulan PRRT65B Service and Adjustments, Tiller, To Adjust Handle Height See Fig, Tire Care

Page 14

SERVICE AND ADJUSTMENTS

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug.

TILLER

TO ADJUST HANDLE HEIGHT (See Fig. 20)

Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil.

•First loosen handle lock lever.

•Handle can be positioned at different settings between “HIGH” and “LOW” positions.

•Retighten handle lock lever securely after adjusting.

HANDLE

(HIGH POSITION)

HANDLE LOCK

LEVER

HANDLE

(LOW POSITION)

FIG. 20

TIRE CARE

CAUTION: When mounting tires, un- less beads are seated,overinﬂation can cause an explosion.

•Maintain 20 PSI (1.4 kg/cm2) of tire pressure. If tire pressures are not equal, tiller will pull to one side.

•Keep tires free of gasoline or oil which can damage rubber.

TO REMOVE WHEEL (See Fig. 21)

•Place blocks under transmission to keep tiller from tipping.

•Remove outer side shield by removing nuts “A” and “B”.

•Remove inner side shield by removing nuts “C” and “D”.

•Remove hairpin clip and clevis pin from wheel.

•Remove wheel and tire.

•Repair tire and reassemble.

	CLEVIS
	PIN
	NUT “C”
	NUT
	“D”
	HAIRPIN
	CLIP
	NUT “B”	INNER SIDE
	NUT “A”	INNER SIDE
	NUT “A”	SHIELD
	OUTER SIDE	SHIELD
	SHIELD

FIG. 21

14

Image 14

Contents PRRT65B Training Safety RulesMaintenance and Storage PreparationTable of Contents OPERATOR’S Position See Fig AssemblyTools Required for Assembly Install Handle See Figs , 4, Unpacking Carton See FigRemove Tiller from Crate Attach Clutch Cable See FigConnect Shift ROD See Fig Check Tire PressureKnow Your Tiller Meets Ansi Safety RequirementsOperation Forward Wheels ONLY/TINES Stopped HOW to USE Your TillerTine Operation with Wheel Drive Reverse Wheels ONLY/TINES StoppedBefore Starting Engine TurningTo Transport ADD GasolineCultivating Tine Shear PinsTilling Hints General Recommendations Lubrication Chart MaintenanceMaintenance Schedule Before Each USEEngine AIR Filter See FigMuffler CleaningCooling System See Fig Spark PlugTiller Service and AdjustmentsTo Adjust Handle Height See Fig Tire CareTo Replace Ground Drive Belt See Figs Ground Drive Belt Adjustment See FigTo Remove Belt Guard See Fig Tine Replacement See Figs , 25, To Adjust Throttle Control Cable See Fig To Adjust CarburetorFuel System StorageOther Engine OILTroubleshooting Points Handle Assembly Tiller - Model Number PRRT65BMAINFRAME, Left Side KEY Part NO. NO. DescriptionMAINFRAME, Right Side 166532 BumperTransmission Tine Shield Tine Assembly Decals Limited Warranty Parts and Service