Poulan PRRT65B owner manual Tine Replacement See Figs , 25

Page 16

SERVICE AND ADJUSTMENTS

TINE REPLACEMENT (See Figs. 24, 25, and 26)

CAUTION: Tines are sharp. Wear gloves or other protection when han- dling tines.

A badly worn tine causes your tiller to work harder and dig more shallow. Most important, worn tines cannot chop and shred organic matter as effectively nor bury it as deeply as good tines. A tine this worn needs to be replaced.

NEW TINE

WORN TINE

FIG. 24

To maintain the superb tilling performance of this machine the tines should be checked for sharpness, wear, and bending, particularly the tines which are next to the transmission. If the gap between the tines exceeds 3-1/2 inches (9 cm), they should be replaced or straightened as necessary.

New tines should be assembled as shown in Fig. 26. Sharpened tine edges will rotate rearward from above.

TRANSMISSION

TINE

TINE

3-1/2" MAX (9 CM)

FIG. 25

SHARP EDGE

HAIRPIN CLIP

COUNTER

TINE

ROTATION

HAIRPIN CLIP

SHARP EDGES

SHEAR PIN

SHARP

SHARP

EDGES

EDGE

 

SHEAR PIN

FIG. 26

SHARP EDGE

16

Image 16
Contents PRRT65B Safety Rules Maintenance and StorageTraining PreparationTable of Contents Tools Required for Assembly AssemblyOPERATOR’S Position See Fig Install Handle See Figs , 4, Unpacking Carton See FigAttach Clutch Cable See Fig Connect Shift ROD See FigRemove Tiller from Crate Check Tire PressureOperation Meets Ansi Safety RequirementsKnow Your Tiller HOW to USE Your Tiller Tine Operation with Wheel DriveForward Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedTurning To TransportBefore Starting Engine ADD GasolineTilling Hints Tine Shear PinsCultivating Maintenance Maintenance ScheduleGeneral Recommendations Lubrication Chart Before Each USEEngine AIR Filter See FigCleaning Cooling System See FigMuffler Spark PlugService and Adjustments To Adjust Handle Height See FigTiller Tire CareTo Remove Belt Guard See Fig Ground Drive Belt Adjustment See FigTo Replace Ground Drive Belt See Figs Tine Replacement See Figs , 25, To Adjust Throttle Control Cable See Fig To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points Handle Assembly Tiller - Model Number PRRT65BMAINFRAME, Left Side KEY Part NO. NO. DescriptionMAINFRAME, Right Side 166532 BumperTransmission Tine Shield Tine Assembly Decals Limited Warranty Parts and Service