Poulan PRRT850X manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 18

STORAGE

Immediately prepare your tiller for storage at the end of the season or if the unit will not be used for 30 days or more.

CAUTION: Never store the tiller with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TILLER

•Clean entire tiller (See “CLEANING” in the Maintenance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS THE CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent.

•Use fresh fuel next season.

NOTE: Fuel stablizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stablizer container. Run engine at least 10 minutes after adding stablizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug.

•Pour 1 ounce (29 ml) of oil through spark plug hole into cylinder.

•Pull starter handle slowly several times to distribute oil.

•Replace with new spark plug.

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your unit indoors and cover it to give protection from dust and dirt.

•Cover your unit with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your unit to rust.

IMPORTANT: NEVER COVER TILLER WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents PRRT850X Training Safety RulesMaintenance and Storage PreparationTable of Contents Assembly Tools Required for AssemblyOPERATOR’S Position See Fig Install Handle See Figs , 4, Unpacking Carton See FigRemove Tiller from Crate Attach Clutch Cable See FigConnect Shift ROD See Fig Check Tire PressureMeets Ansi Safety Requirements OperationKnow Your Tiller HOW to USE Your Tiller To Transport Before Starting EngineADD Gasoline Tine Shear Pins Tilling HintsCultivating General Recommendations MaintenanceLubrication Chart Before Each USEAIR Cleaner See Fig EngineTo Change Engine OIL See Figs Muffler CleaningCooling System See Fig Spark PlugService and Adjustments TillerTire Care Ground Drive Belt Adjustment See Fig To Replace Ground Drive Belt See FigsTine Replacement See Figs , 25, To Adjust Throttle Control Cable See Fig To Adjust CarburetorFuel System StorageOther Engine OILTroubleshooting Points Service Notes Limited Warranty HOPParts and Service Changere DE Pièces LES ET L’ENTRETIEN Limitée Garantie Dépannage DE Guide Moteur EntreposageSupplementaire Information MotobineuseCarburateur LE Régler Pour Réglages ET RévisionMoteur 27 .FIG26 et 25 26 .FIG25 .FIG 24 .FIG Courroie LA Remplacer Pour Fig la Voir Terre À D’ENTRAÎNEMENT Courroie LA Régler23 et 22 .fig les Voir Terre À D’ENTRAÎNEMENTDE Protecteur LE Enlever Pour Fig la Voir Roue LA Enlever PourFig la Voir Roiecour Fig la Voir’ALLUMAGE Bougie EntretienNettoyage SilencieuxFig la Voir AIR À Filtre LubrificationLubrification Générales RecommandationsLubrification DE Tableau Utilisation Chaque AvantDents DES Cisaillement DE Boulons UtilisationBinage 15 .FIG14 .FIG Labourage DE ConseilsMoteur LE Démarrer Pour 13 .FIG’ESSENCE Réservoir LE Remplir Moteur LE Démarrer DE AvantExtérieurs Latéraux Déflecteurs Transporter PourMENT/LESLESEU ROUES-AVANT Marche BineuseMoto Votre Utiliser Comment LA Avec -FRAISES DES UtilisationAnsi Sécurité DE Exigences AUX Conforme Motobineuse Votre ConnaissezMontage Fig la Voir SetesviPoignee LA Installer Et 4, 3, .fig les VoirFig la Voir Carton LE Deballer Fig la Voir D’OPERATEUR Position Montage LE Pour Exiges Outils LESSommaire Client DU ResponsabilitésProduit DE Spécifications Motobineuses des Sécurité toute Sécurité DE RèglesEntreposage ET Entretien En lUtilisation pour ConseilsImportant Manuel

PRRT850X specifications

The Poulan PRRT850X is a robust and efficient tool designed for those who demand quality and performance in their outdoor equipment. As a versatile and powerful trimmer, it has gained popularity among both homeowners and professional landscapers for its reliability and range of features.

One of the standout characteristics of the PRRT850X is its powerful 25cc 2-cycle engine. This engine provides the strength and efficiency needed to tackle tough overgrown lawns and landscaping tasks with ease. It is designed to deliver optimal performance while reducing emissions, making it a more environmentally friendly option in the garden equipment market.

The trimmer features a lightweight and ergonomic design, which significantly enhances user comfort and maneuverability. Weighing in at just over 10 pounds, users can easily handle the tool for extended periods without experiencing fatigue. The adjustable handle allows for personalized setups, further ensuring ease of use.

The dual-line bump feed head is another major highlight of the Poulan PRRT850X. This feature allows for quick and easy line advancement simply by tapping the head against the ground, promoting efficiency during operation. The trimmer is compatible with .095-inch diameter line, suitable for tackling thick grass and weeds without compromising performance.

In addition, the PRRT850X employs advanced technologies such as its Easy Start System, which allows for simple pull starts with minimal effort. This system is particularly beneficial for those who may struggle with traditional starting methods, ensuring a seamless experience right from the beginning.

Additionally, this trimmer boasts a high-impact plastic housing that protects the engine and internal components, ensuring durability and longevity. This feature is essential for those who use the tool in various outdoor conditions, as it maintains performance while withstanding the rigors of heavy use.

The Poulan PRRT850X is also equipped with a straight shaft design, which enhances reach and access to hard-to-reach areas, making it an excellent choice for mowing along fences, walls, and flower beds. It allows for precision trimming and edging, contributing to a well-maintained garden appearance.

Overall, the Poulan PRRT850X combines power, convenience, and durability, making it a valuable addition to any landscaper's toolkit or home gardening equipment. Its thoughtful design and innovative features ensure that users can accomplish their tasks efficiently and effectively, producing professional-quality results every time.
Top Page Image Contents