Poulan HDR500L owner manual Tools Required for Assembly, OPERATOR’S Position See Fig

Page 4

ASSEMBLY

Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1) Utility knife

(1)Tire pressure gauge

(1)Pair of pliers

(1)9/16" wrench

OPERATOR’S POSITION (See Fig. 1)

When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles).

FRONT

LEFTRIGHT

OPERATOR’S

POSITION

FIG. 1

CONTENTS OF HARDWARE PACK
(2) Handle Locks	(1) Carriage Bolt	(1) Center Locknut
	3/8-16 UNC x 1 Grade 5	3/8-16 UNC
(1) Flat Washer 13/32 x 1 x 11 Gauge	(1) Handle Lock Lever	(1) Hairpin Clip
(1) Pivot Bolt
3/8-16 UNC Grade 5	Extra Shear Pins & Clips
	4

Image 4

Contents Model NO. HDR500L Safety Rules Maintenance and StorageTraining PreparationTable of Contents Tools Required for Assembly AssemblyOPERATOR’S Position See Fig Install Handle See Figs , 4, Unpacking Carton See FigAttach Clutch Cable See Fig Connect Shift ROD See FigRemove Tiller from Crate Check Tire PressureOperation Meets Ansi Safety RequirementsKnow Your Tiller HOW to USE Your Tiller Tine Operation with Wheel DriveFORWARD- Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedBefore Starting Engine TurningTo Transport ADD GasolineTo Start Engine See Fig Tilling HintsAdjust Wheels for Cultivating See Figs Tine Shear PinsCultivating Maintenance Schedule MaintenanceGeneral Recommendations AIR Filter See Fig EngineTo Change Engine OIL See Figs Cleaning MufflerSpark Plug Cooling System See FigService and Adjustments To Adjust Handle Height See FigTiller Tire CareTine Replacement See Figs , 25 To Remove Belt Guard See Fig Ground Drive Belt Adjustment See FigTo Replace Ground Drive Belt See Figs To Adjust Throttle Control Cable See Fig To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points Handle Assembly Tiller - Model Number HDR500L180634 180456X428MAINFRAME, Left Side 183122X624 RimMAINFRAME, Right Side 183122X624180677 180627180631 17952012000035 Tine Shield180847 Tine Assembly 184877 Decals184878 Limited Warranty