Troy-Bilt 654J manual Attaching the Control Box

Page 7

Attaching the Control Box

5.Remove the four Phillips screws and lock nuts from the control box plate.

6.Insert the ends of the two springs into the holes found in the control levers located on the underside of the handle panel.

7.Using a Phillips screwdriver and a 7/16” wrench, secure the control box to the underside of the handle panel with the four screws and lock nuts removed earlier.

Image 7

Contents Operator’s Manual Finding Model Number Table of ContentsCustomer Support Operation Important Safe Operation PracticesTraining Preparation Maintenance and Storage Adjacent areas Safety Labels Found on Your TillerAssembling the Tiller Tools Needed for AssemblyAttaching the Handle Attaching the Control Box Oil Attaching the Shift CableGas and Oil Fill-up GasolineWheel Engagement Handle Know Your TillerEngine Starter HandleTine Direction Selector Tine Engagement Lever Handle Height AdjusterDepth Regulator Lever Pre-Start Checklist Safety Interlock SystemStarting Engine Operating the Tiller Stopping EngineStopping the Tiller and Engine Tilling Depths Tilling Tips & TechniquesLoading and Unloading the Tiller Tilling Tips & Techniques CON’TLubrication Maintenance and AdjustmentsCleaning the Tiller EngineChecking Hardware AdjustmentsChanging Oil Checking Oil LevelTine Engagement Cables Shift CableWheel Engagement Cable Changing the Belts ServiceTine Drive Belts Page Wheel Drive Belt ViewTires Removing and Installing TinesTines Tine InspectionProblem Possible Cause Correction TroubleshootingWheels and Tines Model 654J Parts ListHandlebar and Controls Spring, Compression, .39x.60 x .88 Lg 46 a 686-04034 Transmission Ring, Retaining, External, 1.188 Dia Shaft Tine Shield Page TROY-BILT Tiller Lifetime Limited Warranty