General
Troubleshooting
There’s no sound?
1 Make sure the mute function is turned off.
Bubble tubes not bubbling?
1 Make sure stage lights are on.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
2 Check that the volume is turned up by pressing vol.+ button on remote.
3 Make sure ext. / int. switch on back of radio is on int.
(unless you are using external speakers, in which case it should be on ext.)
4 Check to make sure power is turned on.
5 Make sure the LINE IN switch is in the off position if not using an external device.
CD does not play?
1 Check to make sure CD is inserted correctly (label side facing up).
2 It takes approximately 15 to 20 minutes fro the bubble tubes to warm up after the lights are on.
3 If the lights have been on at least 20 minutes and the tubes are still not bubbling, very lightly tap on the Brown plastic at the bottom of the radio with your hand. Only tap very gently and never tap on the tube itself as it could case the tube to break.
The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute risk of electric shock
to persons.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The exclamation point within an equilateral triangle is intended to alert user to the presence of important operating and maintenance (servicing) instruction in the literature accompanying the appliance.
2 Check to see that surface of CD is clean.
3 Make sure radio is on CD function by pressing CD / Radio button.
Remote not working?
1 Replace batteries.
2 Be sure and point remote towards remote sensor when using.
3 Remove obstacles in the path of the remote and the radio so that remote signal has a straight path to the radio.
CAUTION
For Compact Disc Units Only:
INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER BEAM.
Specification
Frequency Range | : FM 87.5 - 108.5 mHz | |
Power Source | : AC 120V ~ 60Hz | |
Power Consumption | : 30W | |
Antenna | : External Antenna for FM | |
Speaker | : 4” Dynamic Type x 2 | |
Speaker Wattage | : 5 | W |
Speaker Ohm | : 4 | Ohm |
Output Wattage | : 2W per channel | |
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
9