Troy-Bilt 12235 owner manual Troubleshooting Problem Possible Cause Corrective Action

Page 14

Section 5: Maintenance

WARNING

Before inspecting, cleaning or servicing the machine, shut off engine, wait for moving parts to stop, dis- connect spark plug wire and move wire away from spark plug.

Failure to follow these instructions can result in serious personal injury or property damage.

TROUBLESHOOTING

Before performing any of the corrections in this Troubleshooting Chart, refer to the appropriate information contained in this Manual and the Engine Owner’s Manual for the correct safety precautions and servicing procedures. Contact your local authorized Engine Service Dealer for engine service. Contact your local authorized dealer for service problems with the machine.

PROBLEM

 

POSSIBLE CAUSE

 

CORRECTIVE ACTION

Engine does not start.

1. Spark plug wire disconnected.

1.

Reconnect wire to spark plug.

 

2.

Out of gas/two-cycle oil fuel mixture.

2.

Check fuel tank. Add fuel mixture.

 

3.

Stale fuel mixture.

3. Drain old mixture. Add fresh mixture.

 

4.

Priming procedure not correct.

4.

Refer to starting procedure in manual.

 

5.

Dirty air filter(s).

5.

Clean or replace air filters.

 

6.

Worn, corroded or broken spark plug.

6.

Replace spark plug.

 

7.

On/Off Switch in OFF position.

7.

Move On/Off Switch to ON.

 

 

 

 

Engine runs poorly or

1. Fouled spark plug.

1.

Remove, inspect, clean spark plug.

has low power under

2. Dirty air filter(s).

2.

Clean or replace dirty air filters.

tilling conditions.

3. Stale fuel mixture.

3.

Drain old mixture. Add fresh mixture.

 

4.

Carburetor out of adjustment.

4. Adjust carburetor. See Manual.

 

 

 

 

Engine overheats.

1. Engine cooling fins clogged.

1.

Remove dirt and debris from fins.

 

2.

Improper amount of oil in fuel mixture.

2.

Drain tank; fill with correct mixture.

 

 

 

 

Tines stop rotating.

1. Object wedged between tines and hood.

1.

Remove wedged object.

 

2.

Internal transmission problem.

2.

Authorized service dealer.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SAFETY AND OPERATING DECALS

Decals are not shown at full size. See Parts List pages for reordering information.

WARNING

Hot surfaces can

cause severe burns.

Do not touch

RevA

muffler or

1904549

adjacent areas.

On rear, left-side tine shield

WARNING

On top, left-side tine shield

On rear, right-side tine

shield

1918221.A(1/00)

On top of handlebar

On right-side handlebar

14

Image 14
Contents Tiller/Edger See Back Cover for Customer Service Information Preparation SafetyTraining OperationNever perform maintenance when SafetyMAINTENANCE/STORAGE Do not put hands or feet near or under rotating partsIntroduction AssemblyAssembly Steps Unpacking InstructionsMixture Ratio is 24 parts gasoline to Part two-cycle oil AssemblyOil GasTILLER/EDGER Controls Features and ControlsKnow Your Equipment Engine ControlsStopping Starting the Engine OperationPRE-START Preparation Starting the EngineTilling and Cultivating Adjusting Tine PatternsOperation CultivatingAttachments Power Lawn Rake Attachment ModelTilling Patterns Lawn Aerator Attachment ModelRequired Maintenance Schedule MaintenanceEquipment Maintenance Engine MaintenanceSpark Plug Cooling System MaintenanceTine Removal Installation Arranging Tines for Narrow TillingArranging Tines For Stony Soil Conditions Off-Season Storage ProcedureStorage Remove the inner tine sectionsTroubleshooting Problem Possible Cause Corrective Action Safety and Operating DecalsParts List Ref # Description QtyModel Parts List Ref # DescriptionPage Safety Rules Maintenance Assembly Model/Serial NumberRecoil Starter Rope Carburetor Repair Parts 15-17 IndexEngine Service and Repair Warranty ServiceReplacement Parts Owner Registration Card