SECTION 4: OPERATING YOUR TILLER
WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.
Before Starting
Gas And Oil Fill-Up
Service the engine with gasoline and oil as instructed in the separate engine manual packed with your tiller. Read instructions carefully.
WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running.
•Stand at side of tiller. Grasp the starter handle and pull out slowly, until it pulls slightly harder. Let rope rewind slowly.
•Pull starter handle rapidly. Do not allow handle to snap back. Allow it to rewind slowly while keeping a firm hold on the starter handle.
•Repeat previous steps until engine starts.
•As engine warms up and begins to operate evenly, move choke lever gradually to RUN position. If engine falters, return to choke position, then slowly move to RUN position.
NOTE: See your engine manual packed with your unit for more detailed instructions.
NOTE: After starting and prior to using the tiller for the first time, be certain to check the clutch adjustment as described in “Checking the Clutch Adjustment” section of the Assembly Instructions.
Starting Engine
NOTE: When pushing the unit with the engine off, you will hear a ratcheting sound (gear noise) which is normal.
WARNING: Be sure no one is standing in front of the tiller while the engine is running or being started.
•Place gear selection lever in NEUTRAL.
•Place the throttle control lever in FAST position or if equipped, place the engine speed control in the START position.
•Move choke lever to CHOKE position or, if equipped, push primer two (2) or three (3) times. Wait about two (2) seconds between each push.
NOTE: A warm engine may not require choking or to be primed.
To Stop Engine
•Move throttle control to STOP or OFF position.
•Disconnect spark plug wire and ground to prevent accidentally starting while equipment is unattended.
NOTE: After the first ten hours of operation, recheck the clutch adjustment. Refer to final clutch adjustment in Assembly Instructions.
Setting The Depth
Tilling depth is controlled by the depth stake which can be adjusted to five different settings. Adjust the side shields as you adjust the depth stake.
WARNING: Be certain spark plug wire is disconnected and grounded against the engine when performing any adjustments.
10