MTD 428C manual Operating the Tiller

Page 11

When using the tiller for the first time, use the second adjustment hole from the top (1" of tilling depth). See Figure 9.

Use This Position

Transport Position

First Time

 

1”

Clevis Pin

3”

 

 

5”

 

7”

Use This Hole For

 

Lowest (Shallowest)

 

Position

Side Shields

 

 

Use This Hole For

 

Highest (Deepest)

 

Position

Figure 9

When breaking up sod and for shallow cultivation, use the setting which gives 1" of tilling depth (second hole from the top). Place the side shields in their lowest position.

For further depth, raise the depth stake and side shields and also make one or two more passes over the area.

When tilling loose soil, the depth stake may be raised to its highest position (use bottom adjustment hole) to give the deepest tilling depth. Raise the side shields to their highest position.

To transport tiller, lower the depth stake (use top adjustment hole).

To adjust the depth stake, remove the clevis pin and hairpin clip. Move the depth stake to the desired setting and secure with the clevis pin and hairpin clip.

See Figure 9.

To adjust the side shields, remove the wing nuts. Move the side shield to the desired position and replace the wing nuts. Tighten securely.

Operating the Tiller

Select the depth stake setting.

Start engine as instructed on the previous page.

Move gear selection handle to one of the forward modes or reverse.

WARNING: Do not move the gear selection handle with the wheels or tines engaged. Make certain the unit is stopped completely before changing the gear selection. A partial engagement may be necessary when engaging tines.

Squeeze the clutch handle against the handle to engage the wheels and tines.

NOTE: Make certain the gear selection indicator is correctly positioned before engaging the clutch handle. If it is between gears, the engine will stall.

To transport tiller, do not engage the tines. Select the wheel drive only.

WARNING: Do not push down on the handles so that the wheels are lifted off the ground while using the tine drive, or the tiller could move backward and cause personal injury.

For best results, it is recommended the garden be tilled twice (lengthwise, then widthwise) to pulverize the soil.

11

Image 11
Contents Operator’s Manual Customer Support Table of ContentsOperation Important Safe Operation PracticesTraining PreparationYour Responsibility Maintenance & StorageTo Remove Unit From Carton Before Assembly Attaching Depth StakeAttaching Handle Assembly Assembling Your TillerAttaching Clutch Cable Attaching Gear Shift RodIf the wheels do not spin with the unit Final Clutch AdjustmentTire Pressure Viewed From Under HandleThrottle Control Know Your TillerGear Selection Handle Clutch HandleFuel Shut-Off Valve If Equipped Handle Adjustment CrankPrimer Button If Equipped Depth StakeStarting Engine Setting The DepthOperating Your Tiller Before Starting Gas And Oil Fill-UpOperating the Tiller Engine Adjustment Handle AdjustmentBelt Tension Adjustment Maintaining Your Tiller Off-Season Storage Trouble Possible Causes Corrective Action Trouble Shooting GuideParts List for Model Series Part Description Model SeriesModel Series Model Series 16 17 Model Series Page Page MANUFACTURER’S Limited Warranty for