SECTION 5: MAKING ADJUSTMENTS
WARNING: Disconnect the spark plug wire and ground it against the engine before performing any adjustments.
Engine Adjustment
Refer to the separate engine manual for engine adjustment instructions.
Wheel Adjustments
To adjust the wheel yoke and wheel position, refer to the Operating Section.
Clutch Control Adjustments
To adjust the clutch controls, refer to the Final Adjustment section of assembly instructions.
Depth Stake Adjustment
To adjust the depth stake, refer to the Operating Section.
Tine Width Adjustment
The tilling width of the unit is 22 inches. Tilling width can be increased to 24 inches by removing the clevis pins and hairpin clips, sliding the outer tines out one inch, and securing in this position with the clevis pins and hairpin clips. For cultivation, reduce the tine width to 13 inches by removing the outer tines completely.
See Figure 13.
22” |
24” |
13” |
Figure 13
SECTION 6: MAINTAINING YOUR TILLER
WARNING: Disconnect the spark plug wire and ground it against the engine before performing any repairs or maintenance.
Engine
Refer to the separate engine manual for engine maintenance instructions.
Maintain engine oil as instructed in the separate engine manual packed with your unit. Read and follow instructions carefully.
Service air cleaner every ten hours under normal conditions. Clean every hour under extremely dusty conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced. To service the air cleaner, refer to the separate engine manual packed with your unit.
IMPORTANT: Never run your engine without air cleaner completely assembled.
The spark plug should be cleaned and the gap reset every 25 hours of engine operation. Spark plug replacement is recommended at the start of each tiller season; check engine manual for correct plug type and gap specification.
Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to permit proper air circulation which is essential to engine performance and life. Be certain to remove all dirt and combustible debris from muffler area.
Lubrication
Pivot Points
Remove the belt cover and lubricate all moving parts and pivot points at least once a season using SAE 30 engine oil.
Chain Drive
The chain case is
11