Cleaning Tine Area, Belt Replacement, Reverse Drive Belt

Cleaning Tine Area

Clean the underside of the tine shield after each use. The dirt washes off the tines easier if rinsed off immediately instead of after it dries. Always towel dry the tiller afterwards and apply a light coat of oil or silicone to prevent rusting or water damage.

IMPORTANT: Never use a "pressure washer” to clean your tiller. Water can penetrate tight areas of the tiller and its chain case and cause serious damage to the unit.

Belt Replacement

Your tiller has been engineered with belts made of special material (Kevlar Tensile). They should not be replaced with an off-the-shelf belt. If belt replacement is required, order belt or belts by part number from your nearest authorized service dealer. See parts list.

Reverse Drive Belt

•Disconnect and ground the spark plug wire against the engine. Remove the belt cover from the left side of the tiller as follows.

•Remove two self-tapping screws and flat washers from the front of belt cover. See Figure 14.

•Remove the hex stop nut and flat washer from the side of the belt cover. Remove belt cover.

•Remove the hex nut which secures the reverse idler pulley to the idler bracket. Slide idler pulley out and remove the belt. See Figure 15.

Reverse Idler	Forward
Pulley	Belt
Hex Nut
Engine Pulley	Reverse Belt
	Transmission
	Pulley

Figure 15

•Reassemble the new belt, following instructions in reverse order. Make certain the reverse drive belt is assembled with the wide side of the belt against the transmission and engine pulleys.

Be certain to adjust the clutch control as instructed in the final clutch adjustment section of assembly instructions.

Hex Washer	Lock Nut &		Forward Drive Belt
Screw	Flat Washer	Belt Cover	• Remove the reverse drive belt as instructed in the
		Belt Cover	previous section.
			previous section.
			• Remove the belt keeper from the idler pulley by
			removing the idler pulley nut.
			• Lift belt off the idler pulley and transmission pulley.
			See Figure 15.
			• Using a 9/16" wrench, remove bolt from engine
			pulley.
			• Push reverse idler pulley bracket forward, and
			remove engine pulley and belt. See Figure 16.
			• Reassemble the new belt, following instructions in
	Figure 14		reverse order. Make certain the forward drive belt is
• Lift the belt off the transmission pulley.			assembled with the wide side of the belt away from
• Lift the belt off the transmission pulley.			the transmission and engine pulleys.
			the transmission and engine pulleys.