Buhler 45 Series warranty Driveline Dimension Contd

Page 13

45 Series Rotary Tiller

DRIVELINE DIMENSION - CONT'D.

7.Pull the driveli ne apart and cut 1/2 of the dimension determined in step 5 from each end. Add another ½ inch (12MM) to each cut off segment.

8.Be sure to use a hacksaw to cut 1/2 from each end of the separated shaft. Cut both the plastic tube and the metal cores.

9.Use a file to remove the burrs from the edges that were cut.

10.Assemble the two ends of the shaft.

11.Make sure that the shaft can telescope freely. If it does not, separate the two parts and inspect for burrs or cuttings on the shaft ends. Be sure it telescopes freely before installing.

12.Make sure the plastic covering shield is free to rotate on the shaft before installing on the machine.

-12 -

Image 13

Contents Table of Contents Description Warranty Labor Warranty ClaimsImportant Facts Introduction Think SAFETY! Work Safely SafetyOperating Safety General SafetyTransport Safety Maintenance SafetyStorage Safety Safety SignsSafety Sign Locations How to Install Safety signsWork Safely Safety Sign Locations cont’d Machine Components Operation To the NEW Operator or OwnerMachine BREAK-IN PRE-OPERATION ChecklistEquipment Matching Horsepower vs. Wid thPoint Hitch Load Sensing HydraulicsDriveline Dimension Driveline Dimension Contd ATTACHING/UNHOOKING Field Operation Field Operation contd Field Operation contd Transporting Speed vs. weight RatioStorage Fluids and Lubricants Service and MaintenanceGreasing Hours or once a season Servicing IntervalsAnnually Servicing Intervals cont’d HoursFrame Adjustment MaintenanceTine Replacement Slip Clutch Clutch MaintenanceProblem Cause Solution Trouble ShootingAssembly Bolt Torque English Torque SpecificationsSeries Tiller Series Rotary Tiller Description Parts List When Ordering PartsPage Page Series Tiller Gearbox #906913 PTO F0409 Series Tiller PTO Parts List Quantity Bundle Required Number Shipping BundlesOptions