Bolens 12229 owner manual Forward Clutch Bail Adjustment, Spark Plug Service

Page 20

20Section 5: Maintenance

WARNING

Before inspecting, cleaning or servicing the machine, shut off engine, wait for all moving parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug.

Failure to follow these instructions can result in serious personal injury or property damage.

FORWARD CLUTCH

BAIL ADJUSTMENT

If the Forward Clutch Bail does not func- tion properly, first check that the forward drive belt is adjusted properly (see Checking and Adjusting Forward Drive Belt Tension). If this fails to correct the problem, contact your authorized dealer for service advice.

ENGINE CLEANING

Keeping the engine clean will help to ensure smooth operation and prevent damage from overheating. Refer to the Engine Owner’s Manual for engine cleaning service intervals and instructions. Be sure that the muffler is cool before ser- vicing the engine.

AIR CLEANER SERVICE

The air cleaner filters dirt and dust out of the air before it enters the carburetor. Operating the engine with a dirty, clogged air filter can cause poor performance and damage to the engine. Never operate the engine without the air cleaner installed. Inspect and service the air cleaner more often if operating in very dusty or dirty conditions. Refer to the Engine Owner’s Manual for air cleaner service intervals and instructions.

ENGINE OIL SERVICE

Check the engine oil level before each use and after every 5 hours of continuous operation. Running the engine when it is low on oil will quickly ruin the engine.

It is recommended that you change the motor oil after every 10 hours of operation and even sooner when operating in extremely dirty or dusty conditions. Refer to the Engine Owner’s Manual for detailed service instructions.

A. To Check the Engine Oil Level:

1.Park the tiller on a level area and shut off the engine.

2.Level the engine (use the Depth Regu- lator Lever to adjust the engine angle).

3.Clean around the oil dipstick or oil fill tube (whichever applies) to prevent dirt from falling into the crankcase.

4.On engines with an oil fill tube, remove the fill cap and add oil (if required) until it reaches the top of the fill tube. Reinstall the fill cap.

5.On engines with a dipstick, remove it and wipe it clean. Reinsert the dipstick, tighten it securely, and remove it. Add oil as needed to bring the level up to the FULL mark. Wipe dipstick clean each time oil level is checked. Do not overfill. Tighten dipstick securely.

B. To Change the Engine Oil:

Change the engine oil as instructed in the Engine Owner’s Manual.

SPARK PLUG SERVICE

Inspect and clean or replace the spark plug after every 100 operating hours or annually. Refer to the Engine Owner’s Manual for spark plug service instructions.

In some areas, local law requires using resistor spark plugs to suppress ignition signals. If the engine was originally equipped with a resistor spark plug, use the same type for replacement.

SPARK ARRESTER SCREEN SERVICE

If the engine muffler is equipped with a spark arrester screen, remove and clean it according to the service intervals and instructions in the Engine Owner’s Manual.

THROTTLE LEVER ADJUSTMENT

If the engine does not respond to various throttle lever settings, refer to the Engine Owner’s Manual for service information or contact your local authorized engine dealer.

WARNING

Operators shall not tamper with the engine governor settings on the machine; the governor controls the max- imum safe operating speed to protect the engine and all moving parts from damage caused by overspeed. Autho- rized service shall be sought if a problem exists.

Image 20
Contents Rear-Tine Tiller Table of Contents Know how to stop the unit and disengage the controls quickly Carefully read this Owner’sSafety Exercise caution to avoid slipping or fallingKeep children and pets away Use slower engine speedsFor your safety and the safety To Avoid Serious InjuryInspect Unit Assembly StepsIntroduction Install Forward Clutch CableAssembly Check Level of Transmission Gear OILOperation SafetyCheck all nuts and screws for tightness Wheel Drive Pins IntroductionEngine Controls FreewheelFeatures and Controls Handlebar Height AdjustmentForward Clutch Bail Depth Regulator LeverPre-Start Checklist BREAK-IN OperationStarting the Engine Avoid engine muffler and nearbyOperating the Tiller OperationTines will cause injury Stopping the Engine and Tiller Stopping the Tiller and EngineClumps of soil that can interfere with Your freshly tilled or cultivated soilBy successive passes at one Quarter width see Fig Hood width, plus enough Extra room for future Plant growthTerrace Gardening Read the following recommendations before tilling on slopesTilling Up and Down Slopes Vertical Tilling Clearing the Tines Loading and Unloading the TillerMaintenance Schedule Transmission Gear OIL ServiceTiller Lubrication Check for OIL LeaksMaintenance Removing/Installing a Single TineRemoving/Installing a Tine Assembly Bolo TinesAgainst the top of the adjuster B Replacement Belt InformationChecking and Adjusting Forward Drive Belt Tension Unhook the top of the spring from the Forward Clutch BailForward Clutch Bail Adjustment Engine Cleaning AIR Cleaner Service Engine OIL ServiceSpark Plug Service Spark Arrester Screen Service Throttle Lever AdjustmentCARBURETOR/GOVERNOR Control Adjustments OFF Season StorageTroubleshooting Problem Possible Cause CorrectionPart Description Parts ListDrawing no Parts List Parts List Drawing no Part Description QTY9512 9727 Forward Clutch Cable 1917326001 Left Side Right Side Hold Tine With Blunt End Toward YouDescription QTY 9711Warranty Service Replacement PartsEngine Service and Repair Owner Registration Card

12229 specifications

The Bolens 12229 is a powerful and versatile lawn tractor designed for homeowners seeking efficiency and reliability in their lawn care routine. This model is well-regarded for its robust construction and user-friendly features, making it suitable for a variety of lawn maintenance tasks.

At the heart of the Bolens 12229 is a dependable 29-horsepower gasoline engine. This provides ample power to handle diverse terrains and thick grass, ensuring a smooth and efficient mowing experience. The engine, combined with a 46-inch cutting deck, allows for coverage of larger areas in a shorter period. The cutting height can be easily adjusted, offering a range of options from 1.5 to 4 inches, accommodating various grass types and personal preferences.

One of the standout features of the Bolens 12229 is its hydrostatic transmission system. This technology offers seamless speed control without the need for gear shifting, allowing users to focus on the task at hand without distractions. The operator can simply press the pedal to accelerate or decelerate, which enhances maneuverability, especially in tight spaces and around obstacles.

The tractor is also equipped with comfortable seating and an ergonomic control layout, ensuring that users can operate it for extended periods without discomfort. Its tight turning radius enhances maneuverability, making it easier to navigate around flower beds and trees.

In terms of storage and utility, the Bolens 12229 comes with a built-in grass catcher option that helps to keep lawns tidy by easily collecting clippings. Additionally, it supports a variety of attachments, such as snow blades and carts, making it a multi-functional tool for year-round yard care.

Safety has not been overlooked; the model features a reliable safety switch that prevents engine start when the operator is not seated. This provides peace of mind, particularly for families with children around the yard.

Overall, the Bolens 12229 stands out in the market for its powerful performance, ease of use, and adaptability. Whether you're mowing a small backyard or tackling a larger landscape, this lawn tractor is designed to meet the demands of modern homeowners while providing excellent value for its price. Its combination of durability and innovative technology makes the Bolens 12229 an excellent choice for efficient lawn maintenance.