Crown Audio MT-601, 1201, 2401 Specifications, 120 VAC, 60 Hz Units, Bridge mono mode

				Micro-Tech Series Power Amplifiers
8 Specifications
Minimum Guaranteed Power	MT-600		MT-1200	MT-2400
120 VAC, 60 Hz Units, Stereo mode, per channel, both channels driven
1 kHz with 0,1% THD
Stereo, 2 ohms (per ch.)	400	W	675 W	1,050 W
Stereo, 4 ohms (per ch.)	325	W	480 W	800 W
Stereo, 8 ohms (per ch.)	220	W	310 W	520 W
120 VAC, 60 Hz Units, Bridge mono mode
1 kHz with 0.1% THD
Bridge mono, 4 ohms	750	W	1,300	2,070 W
Bridge mono, 8 ohms	655 W		970 W	1,585 W
Bridge mono, 16 ohms	450 W		620 W	1,035 W
120 VAC, 60 Hz Units, Parallel mono mode
1 kHz with 0.1% THD
Parallel mono, 1 ohm	700	W	1,300 W	2,080 W
Parallel mono, 2 ohms	665	W	965 W	1, 605 W
Parallel mono, 4 ohms	450	W	620 W	1, 035 W
Performance	MT-600		MT-1200	MT-2400
Frequency Response (at 1 watt, 20Hz - 20 kHz)	± 0.1 dB		± 0.1 dB	± 0.1 dB
Phase Response (at 1 watt, 20Hz - 20 kHz)	±10°		±10°	±10°
Signal to Noise Ratio below full bandwidth power
20 Hz to 20 kHz	>100 dB		>100 dB	>100 dB
A-weighted	>105 dB		>105 dB	>105 dB
Total Harmonic Distortion (THD) at rated power, from 20 Hz to 20 kHz	0.1%		0.1%	0.1%
Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1,
from 163 milliwatts to full bandwidth power	< 0.05%		< 0.05%	< 0.05%
Damping Factor: 10 Hz to 400 Hz	>1000		>1000	>1000
Crosstalk (below rated power, 20 Hz to 20 kHz)	> 60 dB		> 60 dB	> 60 dB
Common Mode Rejection (CMR) (20 Hz to 1 kHz)	> 70 dB		> 70 dB	>70 dB
DC Output Offset (Shorted input)	±10 mV		±10 mV	±10 mV
Input Impedance (nominally balanced, nominally unbalanced)	20 k ohms, 10 k ohms		20 k ohms, 10 k ohms	20 k ohms, 10 k ohms
Load Impedance (Note: Safe with all types of loads)
Stereo	2-16 ohms		2-16 ohms	2-16 ohms
Bridge Mono	4 -16 ohms		4 -16 ohms	4 -16 ohms
Parallel Mono	1-4 ohms		1-4 ohms	1-4 ohms

page 20 Operation Manual