To Install The Th Rottle Control Assembly

TO INSTALL THE TH ROTTLE

CONTROL ASSEMBLY

0Place a No 10 x 1-1/2 inch hex head screw down through the hole in the upper handle right side and attach the throttle control to the underside of the handle (see Fig 5)

HAND GRIPS

FORMED

WASHER

11/32 INCH

FLATWASHER

TEE

KNOB

0 Attach the throttle cable to the right lower handle by

NO. 10 X 1=1/2 INCH

threading a tie strap through the hole in	the lower
handle and around the throttle cable on the	outside of
the handle

0Thread the pointed end of the strap through the other

(square) end of the strap and pull tight around the throttle cable and lower handle.

NOTE: One side of the tie strap is rough, while the other side is smooth The rough side must be on the inside of the Ioopformedwhen the ends of thetie strap are put together

0Try to loosen the tie strap, it it will loosen, it is put together with the smooth side to the inside of the loop Remove the tie strap and reverse the direction

•Out off excess strap

HAND GRIP ASSEMBLY

0Install the hand grips onto the upper handles (see Fig 5). It may be necessary to lubricate the handles with soap and water to aid assembly

HEX HEAD SCREW

THROTTLE

CONTROL

UPPER

HANDLE

HEX

NUT

LEFT

LOWER

,f CHECKLIST

BEFORE YOU OPERATE AND ENJOY YOUR NEW

MINI TfLLER/CULT/VATOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFAC_ TfON FROM THIS QUALITY PRODUCT

PLEASE REVIEW THE FOLLOWING CHECKLIST_ ,/' All assembly instructionshave been completed 4" No remainingiooseparis in carton,

4" All fasteners have been properly installed and tightened WHILE LEARNING HOW TO USE YOUR MINI TtLLER/CULT/-

VATOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:

,J',/ Fuel tank is filled with correct gasoline and oil mixture

v',f Become familiar with all controls-their location and function Operate controls before starting engine

CURVED HEAD

CARRtAGE BOLT

RIGHT LOWEF

HANDLE

TIE STRAP

FIG. 5