Sharp LC-40LE700X Supplying electric power to the antenna, Initial auto installation

Preparation

Supplying electric power to the antenna

When you set-up the DTV antenna for the fi rst time, or connect the antenna to a community antenna, you need to proceed to set the antenna by following this manual.

1	Press DTV to access DTV mode.
2	Press MENU and the MENU screen displays.
3	Press c/d to select “Setup”.
4	Press a/b to select “Antenna setup-DIGITAL”
	and then press ENTER.
5	Press a/b to select “Supply voltage” and
	then press ENTER.
6	Press c/d to select “On” and then press
	ENTER.
Selected item		Description
On		Select “On” when your antenna is set-up
		and connected independently.
		Typical supply voltage: 5V
		Typical supply current: 50mA
Off		Select “Off” when you do not need to
		supply voltage to your antenna, i.e.
		when your antenna is connected to a
		community antenna. (The factory default
		setting of this function is “Off”.)

Initial auto installation

When the TV powers on for the fi rst time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.

Confirm the following before turning on the power

•Is the antenna cable connected?

•Is the AC cord plugged in?

1Press POWER on the TV.

• The initial auto installation wizard appears.

2Setting the on-screen display language.

Display language settings

English

3	Press a/b to select the desired language,
	and then press ENTER.
	Press c/d to select “HOME” or “STORE”,
	and then press ENTER.
			Select the location of TV.
			The picture will be optimized for that location.
			HOME		STORE
	•	HOME: “STANDARD” will be the default value for
		the “AV MODE” setting.
	•	STORE: “DYNAMIC (Fixed)” will be the default
		value for the “AV MODE” setting. If the “AV
		MODE” is changed, the TV will automatically
		switch back to “DYNAMIC (Fixed)” when there is
		no further change to TV setting for 30 minutes.
4	Press ENTER.
			Major Analogue Channel settings are pre-set.
			However, if there are any channel(s) that you
			cannot receive with the factory pre-sets, please
			perform “Auto Installation” in “Setup” section
			(refer chapter “Watching TV” on manual).
				Digital Search
	•	Major Analogue Channel settings are pre-set.
		However, if there are any channel(s) that you
		cannot receive with the factory pre-sets, please
		perform “Auto installation” in “Setup” section.
		(See page 20.)

LC-40LE700X_en_b.indd 11

11

7/8/09 9:34:53 AM