Honda Power Equipment TL5040 manual Lubrication, Every 40 Hours

\

adjusting bail

tractor end

Grease lltllng

Fig. 26

Fig. 25

.- tiller end

Driveline

Fig. 27

LUBRICATION

BEFORE EACH USE

1Driveline Universal Joints - Apply grease to each fitting using grease gun (fig. 27).

2Driveline - Disconnect driveline and separate sections. Apply grease to male tube. Reassemble driveline. (fig. 8)

EVERY 40 HOURS

3Rotor Shaft Bearing - Apply 2-3shots of grease to grease fitting at right end of rotor shaft using hand pump grease gun (fig. 26).

4Input Gearbox - With tiller level, remove oil level check plug on rear of gearbox housing. Correct oil level .isat bottom of check plug.

Add oil if necessary. Gearbox capacity 14 oz.

5Lateral chain housing - With tiller level, remove oil level check plug on side of housing. Correct oil level is at bottom of check plug. Add oil if necessary. Chain housing capacity is 28 oz.

Chain Housing Oil	AGMA 8EP Ind gear oil or SAE 140 GL 5 gear oil
	(when the first oil is unavailable)
Gearbox Oil	SAE 90 or 80 W - 90 wt. oil
Grease	lithium base grease

13