Husqvarna DRT 900 To Replace Ground Drive Belt See Figs, Ground Drive Belt Adjustment See Fig

Page 16

SERVICE AND ADJUSTMENTS

TO REPLACE GROUND DRIVE BELT (See Figs. 23 and 24)

•Remove belt guard as described in “TO REMOVE BELT GUARD”.

•Remove old belt by slipping off engine pulley first then remove from transmission pulley.

•Place new belt in groove of transmission pulley and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES.

•Check belt adjustment as described below.

•Replace belt guard.

•Reposition wheel and replace clevis pin and hairpin clip.

GROUND DRIVE BELT ADJUSTMENT (See Fig. 24)

For proper belt tension, the extension spring should have about 5/8 inch (16 mm) stretch when drive control bar is in “ENGAGED” position. This tension can be attained as follows:

•Loosen cable clip screw securing the drive control cable.

•Slide cable forward for less tension and rearward for more tension until about 5/8 inch (16 mm) stretch is obtained while the drive control bar is engaged.

•Tighten cable clip screw securely.

CABLE CLIP SCREW

ENGINE

PULLEYDRIVE CONTROL CABLE

LESS

TENSION

 

 

MORE

5/8"

 

TENSION

EXTENSION

IDLERSPRING

PULLEYTRANSMISSION

PULLEY

Fig. 24

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents DRT Safety Rules Maintenance and StorageTraining PreparationTable of Contents Tools Required for Assembly AssemblyOPERATOR’S Position See Fig Install Handle See Figs , 4, Unpacking Carton See FigAttach Clutch Cable See Fig Connect Shift ROD See FigRemove Tiller from Crate Check Tire PressureOperation Meets Ansi Safety RequirementsKnow Your Tiller HOW to USE Your Tiller Tine Operation with Wheel DriveForward Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedTurning CultivatingTo Transport Before Starting EngineADD Gasoline To Start Engine See FigTine Shear Pins Tilling HintsMaintenance Lubrication ChartGeneral Recommendations Before Each USEAIR Cleaner See Fig EngineCleaning Cooling System See FigMuffler Spark PlugTiller Service and AdjustmentsTire Care Ground Drive Belt Adjustment See Fig To Replace Ground Drive Belt See FigsTine Replacement See Figs , 26, Storage OtherFuel System Engine OILTroubleshooting Points Repair Parts Handle AssemblyMAINFRAME, Left Side MAINFRAME, Right Side 208cc KEY Part NO. NO. Description Tine Shield Tine Assembly Decals Service Notes Warranty Statement
Top Page Image Contents