Maintenance
Replacing the Belt
Troubleshooting
Off-season Storage
RefertoWARNING:Figure
4Remove the belts from the variable speed pulley. It is not necessary to remove the belt guard on the variable speed pulley. (See figure 15.J
5Reassemble with the new belts.
6 Replace the belt cover.
Caution: You do not have a neutral in your tiller if the belt cover is removed. Install the belt cover before testing.
14
Figure 15
the chart on page 14.
If the machine is to be inoperative | 3 | Disconnect | the spark | plug | wire | ||||||||
for a period longer than 30 days.the | |||||||||||||
| and remove the spark plug from | ||||||||||||
following |
| procedures are |
|
|
| ||||||||
|
|
|
| the cylinder. Pour about 2 or 3 | |||||||||
recommended: |
|
|
|
|
|
| |||||||
|
|
|
|
|
| tablespoons of engine oil into | |||||||
|
|
|
|
|
|
|
| ||||||
1 Working | outdoors. | drain | all | fuel |
| the cylinder, and then turn the | |||||||
| engine over several times to | ||||||||||||
from the fuel tank. Use a clean |
| ||||||||||||
| spread out the oi I. Replace the | ||||||||||||
dry cloth to absorb the small |
| ||||||||||||
| spark plug, but do not connect | ||||||||||||
amount of fuel remaining in the |
| ||||||||||||
| the wire. |
|
|
| |||||||||
tank. then | run | the | engine | until |
|
|
|
| |||||
|
|
|
|
|
| ||||||||
all fuel | in | the | carburetor | is |
| 4 | Clean | the | engine and | the | entire | ||
exhausted. |
|
|
|
|
|
| tiller | thoroughly. |
|
| |||
5 Wipe the entire tiller including
Do not drain fuel while
the tines with an oily rag to
smoking, or if near an open fire.
protect the surfaces.
2 Drain all the oil from the crank- case (this should be done after
the engine has been operated
and is still warm) and refill the
crankcase with clean new oil.
13