Worksaver PF-448 operating instructions Operating Instructions, Operation, Operate Loader Safely

Page 17

OPERATING INSTRUCTIONS

OPERATION

——————————————————

Be sure tractor or skid steer is properly counter- balanced with weights before attempting to lift any load.

Make sure fork latch is properly engaged.

Using the bucket tilt cylinders, adjust the angle of the fork tines so they are parallel with the ground.

Adjust height of fork tines to enter the pallet to be handled. Always keep the load or pallet as close to the forklift main frame as possible.

Make sure weight of load is centered between the forks.

Make sure all operators have read the Owner’s Manual and are familiar with the instructions and the safety rules of operation.

OPERATE LOADER SAFELY

——————————————————

Improper use of loader can cause serious injury or death.

Become familiar with controls.

Be sure anyone operating the loader is aware of safe operation and potential hazards. Read and observe safety recommendations in loader manual.

CAUTION!

Never exceed the lift capacity of the tractor/loader or skid steer used with the loader fork.

CAUTION!

Avoid carrying loose or shiftable loads. Falling items could cause injury.

WARNING!

The Model PF-448 Pallet Fork is NOT to be used for large round bales, as this would create a hazardous condition.

WARNING!

Beware of low electrical wires when loader is raised. Serious injury or death can result if contact is made.

CAUTION!

Beware of lift clearance when raising loader to max- imum height.

Operate loader from operator’s seat only. Remain at controls until operating cycle is complete.

Stop loader gradually when lowering or lifting loads.

Use particular care when working on inclines and hill- sides.

Avoid holes, ditches, and obstructions which may cause tractor/loader to tip.

Allow for additional length of loader on tractor while turning.

Never allow anyone to walk or work under a raised loader.

Be sure that people, livestock, or pets are not standing near the machine while operating.

Do not use the loader for a work platform.

Do not lift or carry anyone on loader or in bucket or attachment.

Carry load low.

Travel slowly over rough ground or when making turns.

Drive slowly through gates and doors.

Avoid carrying loose or shiftable loads.

Lower bucket or attachment to ground when loader is unattended.

16

Image 17
Contents Model no Pallet ForkTo the Owner ContentsDisclaimer of Implied Warranties & Consequential Damages Limited WarrantyThis Warranty Shall not Apply Before YOU Start Important Safety InformationUnderstand Signal Words Equipment Safety Guidelines Safety InstructionsSafety Training Starting and Stopping Safety Safety SignsOperational Safety Operational Safety Safety Instructions Transport Safety Maintenance Safety Storage Safety Maintenance SafetySafety Information Safety SignsReplace Safety Decals If Damaged Or Missing Always Obey ALL Safety Rules Always be CarefulTractor Requirements Preparation Assembly Tractor Loaders PIN on AttachmentInstructions PRE-OPERATION Checklist Assembly Quick AttachAssembly Tractor Loaders Operate Loader Safely Operating InstructionsOperation Replace Safety Signs If Damaged Or Missing Owner ServiceMaintenancetransporting StorageModel PF-448 Parts List WORKSAVER, INC Safety Precautions