Automatic Shutdown and Removal
Robo-Kleen will automatically shut down after a work cycle of approximately 3 hours. Switch off the power supply for at least 30 seconds before restarting.
ALWAYS SWITCH OFF THE POWER SUPPLY BEFORE REMOVING ROBO-KLEEN FROM THE POOL.
Remove Robo-Kleen from the water by GENTLY AND SLOWLY pulling in the cable. WHEN ROBO-KLEEN REACHES THE SURFACE, LIFT IT OUT BY THE HANDLE - NOT BY THE CABLE. To minimize debris falling back into the pool during removal, when the cleaner reaches the surface, QUICKLY GRASP A HANDLE AND TURN UNIT OVER TO REST UPSIDE-DOWN ON TOP LEDGE. ALLOW WATER TO DRAIN OUT THE TOP.
Carefully reel in and coil the cable. Store Robo-Kleen in a dry shaded place at a temperature between 40˚ F and 90˚ F (5˚ C and 32˚ C).
Maintenance
!ALWAYS SWITCH OFF POWER SUPPLY BEFORE PERFORMING MAINTENANCE.
There are only a few simple steps to maintaining your Robo-Kleen.
1)Uncoiling cable
If cable becomes twisted, unplug from power supply and untwist manually. Untwisting manually is most effective after allowing cable to lay in the sun so it becomes pliable.
2)Clean Filter Bag
a. Place Robo-Kleen upside down. Push the locking tabs to the side to unlock the bottom lid. Remove the bottom lid with filter bag attached.