Troubleshooting
Most problems with Verro are caused by a dirty or clogged filter bag. Verro depends on water flowing freely through the filter bag to operate at peak efficiency. If the filter bag gets clogged, Verro will not be able to clean as effectively and may not move as well. The fine filter bag can trap particles as small as two microns across and can be clogged by particles too small to see. If rinsing the filter bag by hand with a hose doesn’t solve the problem, try
If you find the fine filter bag gets clogged too quickly, consider using the mesh bag instead.
Always turn off Verro’s Power Supply and unplug it before troubleshooting any problem.
Problem | likely Cause | What to Do | |
Verro moves | The filter bag needs to | Clean the filter bag. (p. 13) | |
slowly | be cleaned |
| |
|
|
| |
| Flaps in the vacuum | Check the flaps in the vacuum intakes. (p. 20) | |
| intakes at bottom of |
| |
| robot are blocked |
| |
|
|
| |
| Wheels or axles are | Check wheels and axles for dirt and debris. | |
| not turning freely |
| |
|
|
| |
| The pump impeller is | Clean the pump impeller. (p. 17) | |
| fouled by dirt or debris |
| |
Verro does | The filter bag needs to | Clean the filter bag. (p. 13) | |
not cover | be cleaned |
| |
entire pool |
|
| |
Time control dial is not | Set the time control dial. (p. 12) | ||
| |||
| set properly |
| |
|
|
| |
| Floating power cord is | Move Power Supply so that it is near | |
| not positioned to allow | the middle of a long side of the pool. | |
| Verro to reach all of pool |
| |
|
|
| |
| Flaps in the vacuum | Check the flaps in the vacuum intakes. (p. 20) | |
| intakes at bottom of |
| |
| robot are blocked |
| |
|
|
| |
| Wheels or axles are | Check wheels and axles for dirt | |
| not turning freely | and debis. | |
|
|
| |
| The pump impeller is | Clean the pump impeller. (p. 17) | |
| fouled by dirt and debris |
| |
|
|
|
www.irobot.com 21