Troubleshooting (cont...)
Problem | Likely Cause | What to Do |
Verro is not removing | The filter bag needs to | Clean the filter bag. (p. 13) |
attached dirt | be cleaned |
|
and debris |
|
|
| Flaps in the vacuum | Check the flaps in the vacuum intakes. |
| intakes at bottom of | (p. 20) |
| robot are blocked |
|
|
|
|
| The pump impeller is | Clean the pump impeller. (p. 17) |
| fouled by dirt or debris |
|
|
|
|
| Jet tube is blocked | Clean jet tube. (p. 19) |
|
|
|
The floating power | The floating power cord | Use Detangler to untwist the cord. (p. 16) |
cord is tangled | is twisted |
|
or kinked |
|
|
Verro gets stuck on | The floating power cord | Use Detangler to untwist the cord. (p. 16) |
its floating power cord | is twisted |
|
|
|
|
Verro will not start a | Reset required | Turn Power Supply OFF and then back ON. |
cleaning cycle |
| Press reset button. |
|
|
|
| Verro is not plugged | Plug Verro into the Power Supply. |
| into the Power Supply |
|
|
|
|
| The Power Supply is not | Plug the Power Supply into GFCI outlet only. |
| plugged in |
|
|
|
|
www.irobot.com 23