Genie 97550 manual Fall Hazards

Page 4

Operator's Manual

Third Edition • Second Printing

 

 

 

 

 

 

SAFETY RULES

Fall Hazards

Do not use the machine as a personnel lifting platform or step.

Do not stand on the load handling attachments. Do not climb on the mast. Tip-over Hazards

Do not raise the load unless the stabilizers (if equipped) and legs have been fully lowered and locked and the casters are in full contact with the ground.

Do not raise the load unless the leg retainer pins are properly inserted through the leg and the base.

Do not remove the leg retainer pins while the machine is loaded and/or raised.

Do not raise the load unless the machine is on a firm, level surface.

Prior to use, check the work area for drop-offs, holes, bumps, debris, unstable or slippery surfaces or other possible hazardous conditions.

Do not raise the load unless the load handling attachment is properly secured to the machine.

Do not use blocks to level the machine.

Do not move the machine with a raised load, except for minor positioning.

Do not operate the machine in strong or gusty winds. Increasing the load surface area will decrease machine stability in windy conditions.

Do not leave a load raised when windy conditions may occur unless the machine(s) are properly guy- wired.

Do not cause a horizontal force or side load to the machine by raising or lowering a fixed or overhanging load.

2

Genie Superlift Advantage

Part No.97550

Image 4
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessFall Hazards Electrocution Hazards Lifting HazardsBodily Injury Hazard Adjustable Flat Forks Crushing HazardsCollision Hazards Fork ExtensionsDamaged Machine Hazards Decal Legend Improper Use HazardPage Standard Forks Adjustable Forks BoomFlat Forks Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionFunction Tests Setup Function TestsMachines Without Stabilizers Straddle BaseAdjustable Forks and Adjustable Fork Options Load Platform with Adjustable ForksPipe Cradle Standard BoomTest Two-Speed Winch Operation Test One-Speed Winch OperationTest Mast Sequencing Workplace Inspection Operating Instructions Only use the machine as it was intendedMoving Machine with a Load Raising and Lowering LoadAfter Each Use Observe and Obey Load Capacity ChartsForks Load Positioning Instructions Load Capacity Chart Load Center Boom Load Positioning InstructionsMaximum Load Centers ModelLoading the Machine Transport and Lifting InstructionsLoading Machine with a Crane Decals Inspection for Decals with WordsDecals Inspection for Decals with Symbols Decals Specifications SLA-5Specifications