Powermate PM0103000 manual California and Federal Emission Control Warranty Statement

Page 39

I. CALIFORNIA AND FEDERAL EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The California Air Resources Board (CARB) and the United States Environmental Protection Agency (EPA), together with JIANGSU SUMEC-LINHAI POWER MACHINERY CO., LTD. (SLH), are pleased to explain the Emission Control System Warranty on your new small off-road engine. New small off-road engines must be designed, built and equipped to meet stringent anti-smog standards for the state of California and the federal government. JIANGSU SUMEC-LINHAI POWER MACHINERY CO., LTD. will warrant the emission control system on your engine for the periods of time listed below provided there has been no abuse, neglect,

unapproved modification or improper maintenance of your engine.

Your emission control system may include parts such as the carburetor, ignition, intake and exhaust systems. JIANGSU SUMEC-LINHAI POWER MACHINERY CO., LTD. will repair your engine at no cost to you for diagnosis, replacement parts and labor, should a warrantable condition occur.

MANUFACTURER'S WARRANTY COVERAGE:

The 1995 and later small off-road engines are warranted for two years. If any emission related part on your engine is defective, the part will be repaired or replaced by SLH.

OWNER'S WARRANTY RESPONSIBILITIES:

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your owner's manual. SLH recommends that you retain all receipts covering maintenance on your small off-road engine, but SLH cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off-road engine owner, you should however be aware that SLH may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off-road engine to a SLH distribution center as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact Sunright international of America, Phone number 770-729-9065, or write to the following address: Sunright International of America, Inc. 5965 Peachtree Corners E. Ste C-3, Norcross, GA 30071. ATTENTION WARRANTY

DEPARTMENT.

II. EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (ECS Warranty) for 1997 and later model engines:

(a)Applicability: This warranty shall apply to 1997 and later model year engines. The ECS Warranty Period shall begin on the date the new engine or equipment is purchased by/delivered to its ultimate purchaser and shall continue for 24 consecutive months thereafter.

(b)General Emissions Warranty Coverage: SLH warrants to the ultimate purchaser of the new engine or equipments and each subsequent purchaser for a two-year period.

(1)Designed, built and equipped so as to conform with all applicable regulations adopted by the EPA and CARB pursuant to their respective authority, and

(2)Free from defects in materials and workmanship, which, at any time during the ECS Warranty Period, may cause a warranted emissions-related part to fail to be identical in all material respects to the part as described in the engine manufacturer's application for certification.

The ECS Warranty only pertains to emissions-related parts on your engine, as follows:

(1)Any warranted, emissions-related parts that are not scheduled for replacement as required maintenance in the Owner's Manual must be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by SLH according to Subsection (4) below. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(2)Any warranted, emissions-related part that is scheduled only for regular inspection as specified in the Owner's Manual must be warranted for the ECS Warranty Period. A statement in such written instructions to the effect of "repair or replace as necessary" shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(3)Any warranted, emissions-related part that is scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by SLH according to Subsection (4) below. Any such emissions-related part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period prior to the first scheduled replacement point for such emissions-related part.

(4)Repair or replacement of any warranted, emissions-related part under this ECS Warranty shall be performed at no charge to the owner at a SLH Authorized Warranty Service Facility. The warranty services or repairs must be provided at all manufacturer distribution centers that are franchised to service the subject engines.

(5)When the engine is inspected by a SLH Authorized Warranty Service Facility, the owner shall not be held responsible for diagnostic costs if the repair is deemed warrantable.

(6)SLH shall be liable for damages to other original engine components or approved modifications proximately caused by a failure under warranty of any

emission-related part covered by the ECS Warranty.

(7)Throughout the ECS Warranty Period, SLH shall maintain a supply of warranted emission-related parts sufficient to meet the expected demand for such emission-related parts.

(8)Any replacement part may be used in the performance of any Warranty maintenance or repairs and will be provided without charge to the ultimate purchaser. Such use shall not reduce SLH's ECS Warranty obligations.

(9)Add-on or modified parts may not be used. Such use will be grounds for disallowing a warranty claim made in accordance with this article. SLH will not be liable under this article to warrant failures of warranted parts caused by the use of such an add-on or modified part.

EMISSION RELATED PARTS INCLUDE THE FOLLOWING:

1) Fuel Metering System:

a)Gasoline carburetor assembly and its internal components.

b)Fuel filter (if so equipped)

c)Carburetor gaskets

d)Fuel pump (if so equipped)

2)Air Induction System including: a) Intake pipe/manifold

b) Air cleaner

3)Ignition System including:

a)Spark plug

b)Ignition module/coil

4) Miscellaneous Items Used in Above Systems

a)Vacuum, temperature, and time sensitive valves and switches.

b)Hoses, belts, connectors, and assemblies.

English

 

39

 

Customer Hotline 1-800-445-1805

 

 

 

 

 

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Alto StopTable of Contents Table DES MatieresIndice Safety and Operation Rules Spark Arrester Determining Total WattageKW = 1,000 watts Operating Voltage InstallationFuel Before OperationGrounding the Generator LOW OIL SensorL C B Generator FeaturesWheel Installation Portability KIT InstallationApplying Load Starting the UnitPRE-START Preparation Starting the EngineMaintenance Periodic MaintenanceHeat Shield Service and StorageInfrequent Service Exciting the GeneratorEngine Troubleshooting Engine Specifications Powermate Corporation Airport Road Box Kearney, NE Service Information Limited WarrantyRègles D’OPÉRATION ET DE Sécurité SécuritéDétermination DE LA Puissance Totale Nécessaire PARE-ÉTINCELLESVérifier LA Tension Lubrification Avant DE Mettre EN MarcheMise EN Place DE Lappareil CarburantTableau de commande Prise de 120 V, 20 a Caractéristiques DU Groupe ElectrogeneDisjoncteurs Installation DES Roues Linstallation DE KIT DE TransportDémarrage DU Moteur Demarrage DE LappareilPréparatifs AU Démarrage Branchement DES AppareilsLE Type D’HUILE Entretien PériodiqueEntretien LA Bougie D’ALLUMAGEUsage ET Entreposage Depannage DU Moteur Caracteristiques DU Moteur Service Clientele Commande DE Pièces DE RechangeGarantie Limitée Seguridad Reglas DE Seguridad Y DE FuncionamientoComo Determinar EL Vataje Total ApagachispasEL Requerimiento DE Voltaje InstalacionLubricacion Antes DE LA OperacionPuesta a Tierra DEL Generador CombustibleCaracteristicas DEL Generador Instalación DE LA Manija Instalacion DEL Juego DE TransportComo Aplicar UNA Carga Arranque DEL UnidadPreparacion Antes DE Arrancar Arranque DEL MotorTipo DE Aceite Mantenimiento PeriódicoMantenimiento BujiaServicio Poco Frecuente Servicio Y AlmacenamientoExcitacion DEL Generador Escudo DE CalorDeteccion DE Fallos DEL Motor Especificaciones DEL Motor Como Pedir LOS Repuestos Servicio AL Cliente Garantía LimitadaParts Drawing / Schema DES Pièces / Diagrama DE Piezas Part Description Descripción Parts List / Liste DES Pièces / Lista DE PiezasCustomer Hotline California and Federal Emission Control Warranty Statement Powermate Corporation

PM0103000 specifications

The Powermate PM0103000 is a powerful and versatile generator designed to meet the needs of both residential and commercial users. It is particularly popular among construction sites, outdoor events, and emergency situations, providing reliable electricity when it is needed most. One of its standout features is its robust engine, which is engineered for efficiency and longevity. With a potent 10,000 watt peak output and a continuous output of 8,000 watts, the PM0103000 delivers ample power to run multiple appliances simultaneously, making it ideal for heavy-duty applications.

Equipped with a 420cc four-stroke engine, this generator ensures reliable performance and low fuel consumption. It runs on gasoline, providing convenience and ease of use for a variety of settings. The generator includes a large fuel tank that offers extended run time, allowing users to focus on their tasks without frequent refueling interruptions. Additionally, the Powermate PM0103000 features a low-oil shutdown system, which helps protect the engine from damage by automatically turning off the generator when oil levels are too low.

Durability is another key characteristic of the PM0103000. It boasts a rugged steel frame that not only protects the generator components but also enhances its stability during operation. The generator is fitted with pneumatic tires, allowing for easy maneuverability across different terrains. Users will also appreciate the built-in transport handle, which provides added convenience for mobility.

In terms of technology, the PM0103000 incorporates an advanced voltage regulator, offering stable power output to protect sensitive electronics from voltage fluctuations. The inclusion of multiple outlets enhances its functionality, providing several 120V AC outlets as well as a 12V DC outlet for battery charging.

Noise reduction is an essential feature for many users, and Powermate has taken this into account with the design of the PM0103000. The generator is engineered to operate at relatively low noise levels compared to other models in its class, making it suitable for use in residential areas or during outdoor gatherings where noise may be a concern.

In summary, the Powermate PM0103000 generator combines powerful performance with user-friendly features and rugged durability. Its efficient engine, ample power output, advanced voltage regulation, and low noise operation make it an excellent choice for anyone in need of reliable energy in various settings. Whether for emergency preparedness or daily use, the PM0103000 shines as a dependable power solution.
Top Page Image Contents