Powermate P3201, P2201, P2701 owner manual Engine AIR Filter Change, Battery Maintenanc E

Page 24

ENGINE AIR FILTER CHANGE

The generator engine is equipped with a dry element air filter to block particles in the combustion air from getting into the engine and causing excessive engine wear. Over time this dirt builds-up on the filter, restricting the amount of combustion air available to the engine, in turn leading to a loss of generator power output. To avoid these problems, periodic replacement of the engine air filter is recommended at the intervals outline in the service schedule table on page 21. To change the air filter, follow the listed steps.

CAUTION

•Never run this equipment without the complete air filter installed on the engine. Failure to do so will result in premature engine wear and significantly reduced engine life.

1.Using a T30 star drive wrench (not included), remove the 4 screws (A) from the radiator end panel (B) of the generator (see Fig. D).

2.Lift and remove the end panel (B).

3.Remove the air filter (C) by loosening the screw on the clamp (D) with a screwdriver.

4.Replace with a new air filter (see specifications for size).

5.Tighten the clamp screw (D).

6.Replace the end panel and tighten the screws.

Fig. D

BATTERY MAINTENANCE

WARNING

•Read and understand all warnings and cautions on page 15 of this manual before preceding with any battery maintenance.

Correctly maintaining the battery at regular intervals is vital to ensure consistent engine starting. Poorly maintained batteries loose charge over time and may not provide enough power to crank the engine fast enough for reliable starts. The steps below are suggested to care for the battery and charger.

1.Access the battery (E) by removing the front generator panels (F). Insert the key (G) into the top locks and turn 1/4 turn counterclockwise to unlock. Lift the panel up and out of the base and set it aside (see Fig. E). Note: there is no need to turn the locks located on the bottom of the panel.

2.Keep the battery cable clamps (H) at the battery posts tight and free of corrosion. Replace the battery cables if cracks are found in the clamps.

3.Check and adjust the level of battery electrolyte according to the battery manufacturer’s instructions if not using a “maintenance-free” battery. If electrolyte is low, add only distilled water to the battery. Do not add tap water to the battery.

4.Insure the battery charger (I) is powered and functioning properly. A correctly operating battery charger displays lights on the face of the charger to relay the state of the charger. Refer to Table A on page 25 to assess the mode the charger is operating in.

5.Reassemble the front panels (F) to the generator by setting the bottom end of the panel into the base and push into place. Insert the key (G) into the top locks and turn 1/4 turn clockwise to lock.

Fig. E

24

200-2653

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Stationary Standby Electric Generator Model Series P2201Table of Contents General Safety Guidelines General Safety Guidelines Installation Plannin G Introductio NUnpacking Instruction S Generator Specifications P2201 22 KW P2701 27 KW P3201 32 KWInstallation Drawings Location and Generator Placemen TPlacement continue d Utomatic Transfer SwitchElectrical Hookup AIN Line Output Powe RGenerator Start Signal Utility Circuit SupplyWiring Diagram CP200 Controller Fuel Specifications Consumption Require MentsFuel Requirements Fuel Hookup Natural Gas NGBattery Requirement S Battery PlacementConnectio N Nnection con t Lubrication and CoolingFirst Time Startup Control Panel Feature S Generator Operatio NCircuit Breaker Generator Control Panel Operatio N Starting the GeneratorCyclic Crank RUN StateStatus Indicators FaultsMaintenance Engine OIL Level Check Upper Limit Lower LimitEngine OIL and OIL Filter HangeBattery Maintenanc E Engine AIR Filter ChangeTT ERY Maintenanc E con t Spark Plug Chec KAdjustmen T Nclosure and SiteValve Clearance Check Fuel System InspectionTroubleshooting Symptom Possible Cause Corrective ActionTroubleshooting 200-2653 200-2653 Powerstation Automated Power System Limited Warranty Contact the Powermate Product Service Department AT

P2701, P2201, P3201 specifications

The Powermate P3201, P2701, and P2201 portable generators represent a blend of innovation and practicality, designed to provide reliable power for various applications, whether for outdoor activities, home backup, or professional use. These models are distinguished by their powerful engines, user-friendly features, and robust designs, making them ideal companions in situations where electricity is needed most.

The Powermate P3201 generator stands out with its impressive 3200-watt output, allowing it to handle larger appliances and tools. This output comes from a reliable 6.5 HP engine, which provides the necessary power for heavy-duty usage. The P3201 also features a durable steel frame, ensuring longevity and resistance to wear and tear. Its low oil shutdown feature is a highlight, preventing engine damage by automatically shutting off when oil levels are too low. Additionally, the generator is equipped with multiple outlets, including 120V AC and 12V DC, giving users the flexibility to power a variety of devices.

The Powermate P2701 offers a slightly lower wattage at 2700 watts, making it a great choice for users who need reliable power without excess capacity. The 6.5 HP engine offers efficient performance, while the lightweight design ensures portability. Like the P3201, the P2701 also boasts a low oil shutdown feature, alongside a built-in voltmeter for easy monitoring of power output. Its compact design makes it perfect for camping trips or recreational events, while still providing enough power for essential home appliances.

Finally, the Powermate P2201 is tailored for users seeking a compact and efficient generator. With a 2200-watt output, it is suitable for smaller devices, making it an excellent option for tailgating, outdoor gatherings, and backup power for lights and fans. Powered by a 4-stroke engine, the P2201 strikes a balance between efficiency and portability, with an easily transportable frame. The generator's noise-reducing technologies ensure quieter operation, which is a crucial factor in residential areas.

In conclusion, the Powermate P3201, P2701, and P2201 generators cater to a variety of power needs, each offering unique features and strengths. Their robust engines, safety features, and thoughtful engineering make them reliable choices for anyone needing portable power solutions. Whether managing larger power needs or seeking a lightweight generator for casual use, these models deliver performance and convenience.
Top Page Image Contents