Generac SE10000 manual Know Your Generator

Page 6

Generac Portable Products SE10000 Generator

KNOW YOUR GENERATOR

Read this owner’s manual and safety rules before operating your generator.

Compare the illustrations with your generator to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference.

Fuel Tank

Fuel Shut Off Valve

 

Air Filter

(on top of engine)

Circuit Breakers (AC)

Key Switch

120 Volt AC, 20 Amp

Duplex Receptacle

Choke

120 Volt AC, 20 Amp

Locking Receptacle

Oil Filter

120 Volt AC, 30 Amp

120/240 Volt AC, 30 Amp

120/240 Volt AC,

Locking Receptacle

Locking Receptacle

50 Amp Receptacle

 

120 Volt AC, 20 Amp Duplex Receptacle — Each supplies electrical power for the operation of 120 Volt AC, 20 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120 Volt AC, 20 Amp Locking Receptacle — Supplies electrical power for the operation of 120 Volt AC, 20 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120 Volt AC, 30 Amp Locking Receptacle — Supplies electrical power for the operation of 120 Volt AC, 30 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120/240 Volt AC, 30 Amp Locking Receptacle — Supplies electrical power for the operation of 120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120/240 Volt AC, 50 Amp Receptacle — Supplies electrical power for the operation of 120/240 Volt AC, 50 Amp, single phase, 60 Hz welder or motor loads.

Air Filter — Filters intake air as it is drawn into the engine.

Choke — Used to start a cold engine.

Circuit Breakers (AC) — Each receptacle is provided with a circuit breaker to protect the generator against electrical overload. Breakers are "push to reset" type.

Fuel Shut–Off Valve — Always have the fuel shut-off valve closed when engine is not running.

Fuel Tank — Tank holds 10 U.S. gallons of unleaded gasoline.

Key Switch — Used to start engine. Always have key switch in the “Stop” position when not in use.

Oil Filter — Filters engine oil to prolong engine life.

6

Image 6
Contents SE10000 Safety Rules Equipment DescriptionGrounding Generator Never operate the generatorCarton Contents Check Battery / Attach Negative Battery WireRemove Generator from Carton Wheel KIT Installation Install Wheel Kit as follows FigureKnow Your Generator Before Starting the Generator To Start the EngineStopping the Engine Stopping the Engine with the Fuel ValveConnecting Electrical Loads Receptacles120/240 Volt, 50 Amp, Receptacle DON’T Overload the Generator Device Running WattsStorage General Maintenance RecommendationsSpecifications Never operate a damaged or defective generatorGenerac Portable Products SE10000 Generator Troubleshooting Generac Portable Products SE10000 Generator Schematic Diagram Wiring Diagram Generator Exploded View Generator Parts List Qty DescriptionItems Not Illustrated + EMC Alternator Exploded View and Parts ListBEARING, 62052RS C3 FANControl Panel Exploded View and Parts List Axle Wheel KIT Exploded View and Parts ListHandle WheelGenerac Portable Products SE10000 Generator Limited Warranty Consumer Commercial