Generac NP-50LPG, 00919-0 owner manual Fuel Primer, START/STOP Switch, Fuse, Main Breaker

Page 7

® GENERACCORPORATION

Generac NP-50LPG Recreational Vehicle Generator

GENERATOR CONTROL PANEL

Mounted on the generator control panel (Figure 2) are the fol- lowing features:

Figure 2 — Generator Control Panel

FUEL PRIMER

Before starting a cold engine (if it has not been started in more than two weeks), you must press this switch to bring fuel from the tank to the fuel regulator. This rocker type switch springs back into its original position when you release it.

START/STOP SWITCH

To crank and start the engine, hold this switch at its START position. Release the switch when the engine starts. To stop an operating engine, press and hold the switch in its STOP position until the engine shuts off. The switch center position is the RUN position.

FUSE

Protects the engine DC control circuit against electrical over- load. If the fuse element has melted open due to overloading, the engine cannot be cranked. If you must replace it, use only an identical replacement fuse.

MAIN BREAKER

Protects generators AC output circuit against overload and pro- vides a method of turning OFF the generators 120/240 volts AC output to vehicle circuits. The NP-50LPG has one 20 amp breaker and one 30 amp breaker.

NOTE: If the Series NP-50LPG has been reconnected for dual voltage AC output (120/240 volts), you can install line break- ers having an amperage rating that is different than stated above. The replacement line breakers consist of two sepa- rate breakers with a connecting piece between the breaker handles (so that both breakers will operate at the same time). If the unit is reconnected for dual voltage, IT IS NO LONGER

RVIA LISTED.

OPTIONAL REMOTE

START/STOP PANEL

A remote mounted Start/Stop Panel is available, which allows you to start and stop the generator engine conveniently from inside the vehicle.

Figure 3 — Optional Remote Panel (Model 9042)

R e c r e a t i o n a l V e h i c l e G e n e r a t o r

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Generac Generac NP-50LPG Recreational Vehicle Generator Reference Number Identification 20-29 HOW to Obtain Service Operation and MaintenanceRead this Manual Thoroughly Generator AC Connection System InstallationSafety Generator ApplicabilityMain Breaker START/STOP SwitchFuel Primer FuseStarting the Generator Before Starting the EngineApplying Loads to Generator Stopping the GeneratorAutomatic LOW OIL Pressure Shutdown Field BoostOvervoltage Protection Effects of Moisture and Dirt Operating PrecautionsHour Break in Period Hour Check UPEngine OIL Requirements SpecificationsFuel Requirements Fuel ConsumptionChange OIL Filter Checking Engine OIL LevelClean or Replace AIR Filter Engine AIR CleanerBattery Cleaning the GeneratorSpark Arrestor Muffler Exercising the Generator OUT of Service ProtectionReturn the Unit to Service After Storage Drive BeltCause Correction ProblemDrawing No Electrical DataElectrical Data Exploded View Base and Pulleys Description QTY Repair Parts Base and PulleysExploded View Alternator and Panel Repair Parts Alternator and Panel Exploded View Engine Enclosure QTY Description Repair Parts Engine EnclosureDrawing No. B2195 Exploded View GN-410 EngineRepair Parts GN-410 Engine Exploded View Engine Accessories Repair Parts Engine Accessories California Emission Control Warranty Statement Emission Control System Warranty Three Year Warranty Schedule
Top Page Image Contents