General Information
1.1 UNPACKING
•Remove all packaging material.
•Remove separate accessory box.
•Remove the generator from carton.
1.1.1 ACCESSORY BOX
Check all contents. If any parts are missing or damaged, locate an authorized dealer at
• | 1 | - Owner’s manual |
• | 1 | - Oil SAE 30 |
• | 3 | - Product Registration Cards (English, Spanish, French) |
• 2 | - 8” WHEELS | |
• | 1 | - Axle |
• | 1 | - Frame Foot |
• | 1 | - Handle with grip |
• 1 | - Hardware Bag | |
Figure 1 – Wheel Assembly
Figure 2 – Handle Kit
1 | - Plastic Spacer | 2 | - |
1 | - Handle Bracket | 1 | - |
2 | - Rubber Bumpers | 2 | - |
2 | - Cotter Pins | 1 | - |
2 | - |
|
|
1.2 ASSEMBLY
The generator requires some assembly prior to using it. If problems arise when assembling the generator, please call the Generator Helpline at
1.2.1 ASSEMBLING THE ACCESSORY KIT
1x HANDLE BRACKET
1x 
1x PLASTIC SPACER 
1x HANDLE W/GRIP 
BOLTS
1 X
The wheels are designed to the unit to greatly improve the portability of the generator.
NOTICE:
The wheels are not intended for over-the-road-use.
1.Refer to Figure 1 to install the wheels as shown.
•Slide the axle through the frame brackets.
•Slide on the wheels then install the cotter pins.
2.Refer to Figure 1 to install the wheel bumpers as shown.
•Secure the two rubber bumpers to the frame foot using two
•Place the frame foot under the frame and secure with two
3.Refer to Figure 2 to install the handle assembly as shown.
•Install the handle bracket to the frame using two
•Slide the plastic spacer onto the handle assembly then align with the holes in the handle bracket (if not already assembled).
•Secure the handle assembly to the handle bracket using the
2.1 KNOW THE GENERATOR
Read the Owner’s Manual and Safety Rules before operating this generator.
Compare the generator to Figures 3 through 6 to become familiarized with the locations of various controls and adjustments. Save this manual for future reference.
1.120 Volt AC, 20 Amp, Duplex Receptacle – Supplies electrical power for the operation of 120 Volt AC, 20 Amp,
2.120/240V AC, 20 Amp Locking Receptacle – Supplies electrical power for the operation of 120 and/or 240 volt AC, 20 amp,
3.Circuit Breakers (AC) – Each receptacle is provided with a
4.Air Filter – Filters intake air as it is drawn into the engine.
5.Choke Knob – Used when starting a cold engine.
6.Fuel Tank – Tank holds 4 U.S. gallons of fuel.
7.Grounding Lug – Ground the generator to an approved earth ground here. See "Grounding the Generator" for details.
8.On/OFF Switch – Controls the operation of the generator.
4