PowerBOSS™ | 5500W Portable Generator | ASSEMBLY |
|
|
|
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
Unpacking the Generator
1.Set the carton on a rigid flat surface.
2.Remove everything from carton except generator.
3.Open carton completely by cutting each corner from top to bottom.
4.Leave generator on carton to install wheel kit.
Carton Contents
Check all contents. If any parts are missing or damaged, call the generator helpline at
•30 Amp extension cord
•Wheel kit
Install Wheel Kit
NOTE: Wheel kit is not intended for
•2 - 13mm wrenches
•Socket wrench with a 13mm socket
•Pliers
•Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1.Tip generator so that engine end is up.
2.Slide axle through both mounting brackets.
3.Place a wheel on each side with air valve facing out.
4.Place a washer on axle and then place an
5.Install
•The generator
•Generator operator’s manual
•Engine operator’s manual
•Engine oil
•Three packets of fuel stabilizer
Figure 1 — Install Wheel Kit
CAUTION
• Always wear eye protection when installing/removing
Capscrew |
|
|
Nut |
|
|
Handle |
|
|
|
| Washer |
| Axle |
|
Support Leg | Capscrew |
|
Nut | Wheel | |
| 6 |
|