Chicago Electric 65588 manual Cleaning, Maintenance, Lubrication Schedule

Page 13

Fuel Filter Replacement (if equipped)

WARNING! To prevent serious injury from fire:

Replace the fuel filter in a well-ventilated area away from igni- tion sources. Do not smoke.

1.Wait for engine to cool completely before proceeding.

2.Wear protective gear including, ANSI- approved safety goggles, NIOSH- approved dust mask/respirator, and nitrile gloves.

3.Close fuel valve leading from gas tank completely.

4.Take note of the fuel filter’s orienta- tion.

5.Place a suitable container under the fuel filter.

6.Disconnect the fuel lines leading to and from the fuel filter and allow fuel to drain onto the container.

7.Install new fuel filter in the same orientation. Make sure to properly secure both fuel lines.

8.Clean up and properly dispose of all fuel.

9.Wait for at least one hour before use to allow all residual fuel vapors to dissipate. To prevent fire, do not start the engine while the smell of fuel hangs in the air. Remember to open the fuel valve before restarting the engine. It may take a little longer than usual to start the engine be- cause the fuel needs to refill the fuel line and new filter.

Cleaning, Maintenance, and

Lubrication Schedule

Note: This maintenance schedule is intended solely as a general guide. If performance decreases or if equip- ment operates unusually, check sys- tems immediately. The maintenance needs of each piece of equipment will differ depending on factors such as duty cycle, temperature, air quality, fuel quality, and other factors.

Note: These procedures are in addition to the regular checks and maintenance explained as part of the regular op- eration of the engine and equipment.

After Initial 20 Operation Hour Period:

a. Change engine oil.

Every 25 Operation Hours Thereafter:

a. Clean/replace air filter element.

b. Inspect/clean spark plug.

Every 50 Operation Hours:

a. Change engine oil.

b. Replace fuel filter (if equipped).

Every 100 Operation Hours:

a. Replace spark plug.

b. Replace air filter element.

Note: All maintenance procedures sched- uled for 25, 50, and 100 operation hours should be performed at least yearly.

Every 300 Operation Hours:

a. Clean fuel tank and carburetor.

b.Clean carbon build-up from combus- tion chamber.

SKU 65588

For technical questions, please call 1-800-444-3353.

Page 13

Image 13
Contents Distributed exclusively by Harbor Freight Tools For technical questions or replacement parts, please callContents Save This Manual Set up precautionsCarbon Monoxide Hazard Using an engine indoors Operating precautionsService precautions Refueling Precautions Basic SpecificationsUnpacking Operating Instructions Oil type Checking and Filling Engine OilChecking and Filling Fuel Equipment Operation Maintenance Procedures Technical SpecificationsAir Filter Element Maintenance ServicingCleaning Cleaning, Maintenance, Lubrication Schedule Storage Troubleshooting Engine backfires Problem Possible Causes Probable Solutions Engine knocksBody Parts List a Parts Lists and DiagramsBody Diagram a Part Description ’tyGenerator Diagram B Generator Parts List BPart Discription ’ty Engine Parts List CEngine Assembly Diagram C Record Product’s Serial Number Here Limited 1 year / 90 Day warrantyManufacturer’s Warranty Coverage Emission Control System WarrantyFor technical questions, please call