Changing/Adding Oil
The oil level in this generator should be checked before each use. (See Figure 10.) When the oil level is low, add oil until the level is sufficient to operate this generator.
The oil capacity for this ACDelco Model
To drain the oil from this generator:
It is necessary to drain the oil from the crankcase only if it has become contaminated with water and/or dirt.
1.Place a bucket underneath this generator to catch oil as it drains.
2.Using a 10 mm hex wrench, unscrew the oil drain plug located on the crankcase underneath the oil filler/dipstick cap as illustrated in Figure 12.
3.Allow all the oil to drain from this generator.
4.Replace the oil drain plug and tighten with a 10 mm hex wrench.
NOTE: Never dispose of used motor oil in the trash, down a drain or on the ground. Put oil in a sealed container and contact your local recycling center or auto garage to arrange oil disposal.
To add oil to the engine crankcase:
1.Confirm that this generator is on a level surface.
2.Unscrew the oil filler/dipstick cap from the engine as illustrated in Figure 11 above.
3.Using a funnel, add high detergent motor oil to fill the engine crankcase to the correct quantity.
Model | 1.2 / 38 / 1.13 |
Model | High Detergent Motor Oil, |
Figure 12 - Draining Oil | Figure 13 - Adding Oil |
Air Filter Maintenance
Routine maintenance of the air filter helps maintain proper airflow to the carburetor.
Occasionally verify that the air filter is free of excessive dirt. The air filter will require more frequent cleaning when operating this generator in extremely dusty areas.
1.Unhinge the clasps at the top and bottom of the air filter cover as shown in Figure 14.
2.Remove the
3.Wipe the dirt from inside the empty air filter casing.
4.Wash the
5.Allow the
Model | 21 |