MTD H660G manual Drive Belt

Page 15

Belt

Cover

Self-Tapping

Screws

Figure 20

Roll the front and rear auger belts off the engine pulley. See Figure 21.

Rear Auger

Drive

 

Belt

Belt

Engine

 

 

Pulley

Idler

Front Auger

Belt

Pulley

 

 

Engine

Idler

 

Pulley

 

Pulley

 

 

Figure 21

Unhook the idler spring from the hex bolt on the auger housing. See Figure 22.

Back out the stop bolt to allow the belts to slip between the bolt and auger pulley. See Figure 23.

NOTE: It may be necessary to loosen the six hex nuts that fasten the frame to the auger housing.

Lift the rear auger belt from the auger pulley, and slip belt between the support bracket and the auger pulley. See Figure 22. Repeat this step for front auger belt.

Replace both auger drive belts by following instructions in reverse order.

 

 

Friction

 

 

 

Wheel

 

Support

 

 

 

 

Bracket

 

 

 

 

Rear Auger

 

 

 

Frame

Belt

 

 

 

 

 

 

 

Front Auger

 

 

 

Support

Pulley

Auger

 

Auger

Bracket

 

Pulley

Idler

Housing

Spring

 

 

Spring

 

Figure 22

Drive Belt

Follow steps 1 through 4 of previous instructions.

Pull idler pulley up, and lift belt off engine pulley and friction wheel disc. See Figure 21.

Back out the stop bolt until the support bracket rests on the auger pulley. See Figure 23.

Slip belt between friction wheel and friction wheel disc. Remove and replace belt. Reassemble following the instructions in reverse order.

NOTE: The support bracket must rest on the stop bolt after the new belt has been assembled. See Figure 23.

Friction

Friction Wheel

Wheel

 

Disc

 

 

Drive Belt

Stop

Bolt

Support Bracket

Figure 23

15

Image 15
Contents Operator’s Manual Table of Contents Training Important Safe Operation PracticesMaintenance and Storage Assembly Assembling Your Snow ThrowerLoose Parts Chute Directional Control Know Your Snow ThrowerShift Lever Auger/Traction ControlFuel Shut-Off Valve optional equipment Heated Handles SwitchChute Clean-Out Tool Ignition KeyStarting Engine Operating Your Snow ThrowerBefore Starting Gas And Oil Fill-upTo prevent starter freeze-up To Stop EngineTo Engage Drive To Engage AugersOperating Tips Traction Control and Shift Lever Tire Pressure Pneumatic TiresSkid Shoes Chute AssemblyShift Rod Auger ControlLubrication Maintaining Your Snow ThrowerAugers ServiceBelt Replacement Shave Plate and Skid Shoes EngineDrive Belt OFF-SEASON Storage Changing Friction Wheel RubberTrouble Possible Causes Corrective Action Trouble Shooting GuideParts List Model H660G Drive Clutch Cable Auger Clutch Cable Part Description 4647 3813 Model H660G MANUFACTURER’S Limited Warranty for