MTD E640F, E660G, E610E manual Finding Your Model Number, Calling Customer Support

Page 4

SECTION 2: FINDING YOUR MODEL NUMBER

This Operator’s Manual is an important part of your new snow thrower. It will help you assemble, prepare and maintain your snow thrower. Please read and understand what it says.

Before you start to prepare your snow thrower for its first use, please locate the model plate and copy the information from it in this Operator’s Manual. The information on the model plate is very important if you need help from your dealer or the MTD customer support department.

Every snow thrower has a model plate. You can locate it by standing behind the unit in the operating position and looking down at the rear frame below the engine.

The model plate will look like Figure 2.

This is where your model number will be.

XXX-X-XXX-X-XXX XXXXXXXXXXX

This is where your serial number will be.

 

Copy the model number here:

MTD PRODUCTS INC

Copy the serial number here:

 

 

 

 

CLEVELAND, OHIO 44136

 

 

 

 

 

 

 

 

 

 

Figure 2

SECTION 3: CALLING CUSTOMER SUPPORT

If you are having difficulty assembling this product or if you have any question regarding the controls, operation or maintenance of this snow thrower, please call the Customer Support Department. You can reach them by calling:

1-800-800-7310

Before you call, make sure that you have both your model and serial number ready. By having the model and serial number ready, you help the Customer Support Representative give you faster service. To find your units model and serial number, see SECTION 2: FINDING YOUR MODEL NUMBER.

4

Image 4
Contents Important Read Safety Rules and Instructions Carefully MTD Products INC. P.O. BOX 368022 CLEVELAND, OhioImportant Safe Operation Practices TrainingPreparation OperationMaintenance and Storage Finding Your Model Number Calling Customer SupportContents of Hardware Pack Assembly Instructions Tools Required for AssemblyUnpacking Loose Parts in Carton See FigureHardware a Attaching the Handle AssemblyAttaching the Clutch Cables Attaching the Chute Assembly Hardware B Attaching the Chute Crank Hardware CAttaching the Shift ROD Hardware D Final AdjustmentsAuger Drive Clutch Traction Drive Clutch and Shift Lever Adjustment Adjusting the Skid ShoesControls Tire Pressure Pneumatic TiresOperation Recoil Starter Electric StarterTo Stop Engine Adjustments Lubrication Maintenance Belt Removal and Replacement Auger Belts Drive BeltOFF-SEASON Storage Changing Friction Wheel RubberTrouble Shooting Guide Gear Assembly All Models Blower Housing Part Description QTY Handle Assembly Handle Assembly Frame Assembly Wheel Assemblies Model no Size Engine and V-Belts E640F E660G MANUFACTURER’S Limited Warranty for