Poulan Repair Parts Snow Thrower Model PP1053ES BAG of Parts, 35062, Safety Ignition KEY

Page 37

REPAIR PARTS SNOW THROWER - MODEL PP1053ES (96192001803)

BAG OF PARTS

6 7

KEY	PART	DESCRIPTION
NO.	NO.	DESCRIPTION

10 11

1	198563	POWER CORD
2	169675	RETAINER PIN
3	180684	WRENCH
4	184505	REMOTE SPRING

5179829 SHOULDER BOLT 1/4−20

6179246 NYLON WASHER 1/4−20

7191730 LOCKNUT 1/4−20

872250505 CARRIAGE BOLT 5/16−18 X 5/8

9751153 LOCKNUT 5/16−18

1073800600 LOCKNUT 3/8−16

2	1	14
	1	13
		13
	12	01.14.003-A

11	19131316	WASHER 3/8
12	198636	SHEAR BOLT 1/4−20 X 1−3/4
13	198638	SPACER
14	73800400	LOCKNUT 1/4−20

KEY	PART	DESCRIPTION
NO.	NO.	DESCRIPTION
1	35062	SAFETY IGNITION KEY

01.14.008-A

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Image 37

Contents Snow Thrower Model NumberSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Chute Deflector Remote ControlEXT RA Shear Bolts and Nuts Rotator Head MountingHOW to SET UP Your Snow Thrower Assembly / PRE-OPERATIONRemove Snow Thrower from Carton Unfold Upper HandleInstall Auger Control ROD See Figs Install Traction Drive Control ROD See FigsInstall Chute Deflector Remote Control See Figs Install Discharge Chute / Chute Rotater Head See FigCheck Tire Pressure Know Your Snow Thrower OperationPrimer Ignition KEYRecoil auxiliary starter handle used for starting engine Meets A.N.S.I. Safety RequirementsStopping HOW to USE Your Snow ThrowerPower Steering Operation See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig To Move Forward and Backward See FigBefore Starting the Engine To Adjust Skid Plates See FigCheck Engine OIL Level See Fig ADD Gasoline See FigTo Start Engine Snow Throwing TipsBefore Stopping If Recoil Starter has FrozenGeneral Recommendations MaintenanceBefore Each USE LubricationSnow Thrower CleaningEngine To Adjust Snow Thrower Height Service and AdjustmentsChute Deflector Shear Bolts See FigTo Replace Belts See Fig Other StorageTroubleshooting Exploded KEY Part Description Scrapper BAR Auger HousingAuger Bearing Bearing PlugAuger Assembly 30 RH Auger Assembly 30 LHChute Weldment Deflector Control AssemblyDeflector Weldment Deflector SealRotator Head LEVER/CABLE Rotator AssemblyRotator Pivot Bracket Pulley PivotRepair Parts Snow Thrower Model PP1053ES Handles Knob RED SpacerHandle Knob Washer 3/8Traction ROD Assembly Impeller ROD AssemblyShifter ROD TOP Shifter ROD BottomPart KEY Description Repair Parts Snow Thrower Model PP1053ES 96192001803DRIVE Drive Plate Assembly Speed Selector AssemblyEND Plate Bottom PANAxle Shaft Repair Parts Snow Thrower Model PP1053ES DriveSprocket LH358SA-159628A KEY Part Description Tecumseh Engine Model417014X428 Engine Mount Plate Traction Belt Belt CoverImpeller Belt Repair Parts Snow Thrower Model PP1053ES Wheels Cable Bracket RH Cable Bracket LHSafety Ignition KEY Repair Parts Snow Thrower Model PP1053ES BAG of Parts35062 181037 Repair Parts Snow Thrower Model PP1053ES DecalsDECAL, Danger Service Notes Limited Warranty

REPAIR PARTS SNOW THROWER - MODEL PP1053ES (96192001803)

BAG OF PARTS

KEY

REMOTE SPRING

WASHER 3/8

SPACER

KEY

35062

SAFETY IGNITION KEY