Poulan P10530ESA owner manual Storage, Other

Page 18

TO REMOVE WHEELS (See Fig. 24)

•Remove the klik pin and remove wheel from axle.

IMPORTANT: When installing wheel, be sure to use the in- nermost hole in axle and the wheel hub hole. To disengage drive system from the wheels (for pushing or transporting the snow thrower), remove klik pin from wheel hub and insert pin into the outermost hole in axle only.

KLIK PIN

OUTER HOLE

 

INNER

 

HOLE

WHEEL

WHEEL HUB

FIG. 24

NOTE: To seal punctures or prevent fl at tires due to slow leaks, tire sealant may be purchased from your local parts dealer.Tire sealant also prevents tire dry rot and corrosion.

ENGINE

See engine manual.

CARBURETOR

Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 7,000 feet (2,134 meters). If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualifi ed service center.

ENGINE SPEED

Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the engine-governed high speed needs adjusting, contact a qualifi ed service center, which has proper equipment and experience to make any necessary adjustments.

STORAGE

Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.

WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. Allow the engine to cool before storing in any enclosure.

SNOW THROWER

When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire snow thrower (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See “TO RE- PLACE BELTS”in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

1.Drain the fuel tank.

2.Start the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in min- imizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (30 ml) of oil through spark plug hole into cylinder.

3.Pull recoil starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

•Do not store gasoline from one season to another.

ENGINE

 

• Replace your gasoline can if your can starts to rust.

See engine manual.

 

Rust and/or dirt in your gasoline will cause problems.

FUEL SYSTEM

 

• If possible, store your snow thrower indoors and cover

 

it to protect it from dust and dirt.

IMPORTANT: It is important to prevent gum deposits from

 

 

• Cover your snow thrower with a suitable protective cover

forming in essential fuel system parts such as carburetor,

 

 

that does not retain moisture.Do not use plastic.Plastic

fuel hose, or tank during storage.Also, alcohol blended fuels

 

 

cannot breathe, which allows condensation to form and

(called gasohol or using ethanol or methanol) can attract

 

 

will cause your snow thrower to rust.

moisture which leads to separation and formation of acids

 

 

IMPORTANT: Never cover snow thrower while engine/

during storage. Acidic gas can damage the fuel system of

 

an engine while in storage.

18

exhaust area is still warm.

 

 

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Model Number Snow ThrowerOperation TrainingPreparation Static Electricity HazardMaintenance and Storage API-SF-SJ14-15 Service and AdjustmentsParts Packed Separately in Carton 16-18Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper HandleInstall Auger Control ROD See Figs Install Discharge Chute / Chute Rotater Head See FigInstall Chute Deflector Remote Control See Figs Install Weight BAG See FigCheck Tire Pressure Operation Know Your Snow ThrowerMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineHOW to USE Your Snow Thrower StoppingPower Steering Operation See Fig To Throw Snow See FigTo Move Forward and Backward See Fig Before Starting the Engine Scraper BARTo Start Engine Snow Throwing Tips Before StoppingIf Recoil Starter has Frozen Before Each USE MaintenanceGeneral Recommendations LubricationCleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Storage OtherTroubleshooting Page KEY Part Description Page 183334 Knob, Lever Repair Parts Snow Thrower Model Number P10530ESA Handles Repair Parts Snow Thrower Model Number P10530ESA Handles Repair Parts Snow Thrower Model Number P10530ESA Drive Washer, Flat Page KEY Part Description Page KEY Part Description Limited Warranty

P10530ESA specifications

The Poulan P10530ESA is a robust and versatile outdoor power tool designed to meet the diverse needs of homeowners and landscape professionals alike. Known for its ease of use and reliability, this gas-powered string trimmer offers a range of features and technologies that make it an exceptional choice for tackling yard maintenance tasks.

At the heart of the Poulan P10530ESA is its powerful 30cc engine, which delivers impressive cutting performance while maintaining fuel efficiency. This engine is designed with a lightweight structure, making the trimmer easy to maneuver during extended use. The inclusion of a dual-line cutting head allows for more efficient trimming and enables users to cut larger swathes of grass in less time compared to single-line models.

One of the standout features of the P10530ESA is its easy-to-start technology. The trimmer is equipped with a primer bulb and a choke to ensure quick and effortless starting, even after long periods of storage. This user-friendly design is ideal for those who may not be experienced with gas-powered equipment, removing barriers to starting the trimmer and getting to work.

The Poulan P10530ESA also showcases a unique curved shaft design. This ergonomic feature provides enhanced comfort and reduces user fatigue, making it suitable for tasks that require precision cutting in tight spaces or difficult angles. Additionally, the handle of the trimmer is adjustable, allowing users to customize the height for better control and comfort during operation.

Another important characteristic of the P10530ESA is its durability. Built with high-quality materials, this trimmer is designed to withstand the rigors of regular use while maintaining reliable performance. The outer casing protects internal components from debris and damage, extending the trimmer's lifespan.

Moreover, the Poulan P10530ESA is compatible with various accessories, including brush cutters and edging attachments, making it a versatile tool for different landscaping needs. Its ability to easily switch between applications adds to its overall value and functionality for users.

In summary, the Poulan P10530ESA combines power, ease of use, and durability, making it an excellent investment for anyone looking to maintain their yard efficiently. With its advanced features and thoughtful design, this string trimmer is sure to provide exceptional performance, whether for occasional yard work or regular landscaping tasks.
Top Page Image Contents