HOW to SET UP Your Snow Thrower, Tool BOX See Fig

PARTS PACKED SEPARATELY IN CARTON

Read these instructions and this manual in its entirety before		speed control rod to lower handle.
you attempt to assemble or operate your new snow thrower.		4. Remove snow thrower from carton and check carton

Your new snow thrower has been assembled at the factory		thoroughly for additional loose parts.
with the exception of those parts left unassembled for ship-		HOW TO SET UP YOUR SNOW THROWER
ping purposes. All parts such as nuts, washers, bolts, etc.,
necessary to complete the assembly have been placed in		TOOL BOX (See Fig. 8)
the parts bag. To ensure safe and proper operation of your
		A toolbox is provided on your snow thrower. The toolbox is
snow thrower, all parts and hardware you assemble must
be tightened securely. Use the correct tools as necessary		located on top of the belt cover. Store the extra shear bolts,
to ensure proper tightness.		nuts and multi-wrench provided in parts bag in the toolbox.
REMOVE SNOW THROWER FROM CARTON		NOTE: The multi-wrench may be used for assembly of the
		chute rotator head to snow thrower and making adjustments
1. Remove all accessible loose parts and parts boxes		to the skid plates.
	from carton.	UNFOLD UPPER HANDLE
2.	Cut down all four corners of carton and lay panels ﬂat.
		1. Raise upper handle to the operating position and tighten

3.	Remove all packing materials except plastic tie holding 4	handle knobs securely.