OPERATION
SPARK | ENGINE OIL CAP | AUGER |
PLUG | WITH DIPSTICK | CONTROL |
SAFETY |
| LEVER |
IGNITION |
|
KEY | GASOLINE |
| |
| FILLER |
| CAP |
CHOKE | CHUTE | |
DEFLECTOR | ||
CON- | ||
| ||
TROL |
|
OIL
DRAIN
PLUG
THROTTLE / ENGINE CONTROL
DISCHARGE
CHUTE
RECOIL
STARTER
HANDLE
FUEL
PRIMER |
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
FIG. 8
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Recoil starter handle - used for starting the engine. |
|
Primer - pumps additional fuel from the carburetor to the |
|
cylinder for use when starting a cold engine. |
|
Throttle/engine control - used to select either FAST or |
|
SLOW engine speed and to STOP the engine. |
|
Choke control - used for starting a cold engine. | 9 |
|
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.