Simplicity 3190E, 3190M important safety instructions PRE-START Check List, Gasoline Cycle OIL

Page 5

Section 2 - OPERATING INSTRUCTIONS

2.1PRE-START CHECK LIST

Make the following checks and perform the service required before each start-up.

2.1.1.Check guards, chutes, deflectors and covers to make sure all are in place and securely tightened.

2.1.2.Check auger control to insure it works freely. See Figure 2.1.

AUGER

CONTROL

ENGAGE AND

DISENGAGE AUGER

CONTROL TO INSURE

PROPER OPERATION

FIGURE 2.1

2.1.3.Check chute operation. Rotate chute to insure smooth rotation throughout its range.

STANDARD FLUID MEASUREMENT (32:1 Ratio)

GASOLINE

2 CYCLE OIL

(Gallons)

(Ounces)

0.25

1.00

0.50

2.00

0.75

3.00

1.00

4.00

1.25

5.00

1.50

6.00

2.00

8.00

METRIC FLUID MEASUREMENT (32:1 Ratio)

GASOLINE

2 CYCLE OIL

(Liters)

(Cubic Centimeters)

0.50

15.63

1.00

31.26

1.50

46.88

2.00

62.50

2.50

78.15

3.00

93.75

4.00

125.00

FIGURE 2.2

(Continued on Next Page)

WARNING

Use approved fuel container. DO NOT smoke near open fuel container. DO NOT fill fuel tank indoors or when engine is running. Allow engine to cool for at least ten minutes before refilling. Wipe off any spilled fuel before starting engine. DO NOT run engine indoors.

2.1.4.Mix fresh, good quality unleaded gasoline and SNAPPER 2-cycle engine oil or equivalent. Mix fuel and oil to a 32:1 ratio. See Figure 2.2.

2.1.5.Add premix fuel to tank after pushing the machine outside where fumes can safely dissipate. Make sure cap is tightened after refueling. Refer to Engine Owners Manual for fuel specifications.

2.1.6.Check auger housing, must be free of all obstructions. Clean engine of any accumulation of spilled fuel, dirt, etc.

5

Image 5
Contents Engine HP Engine Options Auger Width Series Designation Model Number ExplanationPreparation Operational PrecautionsProtection for Children Safe Handling of Gasoline Maintenance and StorageTable of Contents Gasoline Cycle OIL PRE-START Check ListMinimum Gauge for Cord Sets Engaging Auger Move choke control to the choke on position. See FigureStopping Operating Instructions Storage Procedure Service After First 5 Hours Check Auger Drive BeltIntroduction Check Auger Flite ShoeAuger Belt Idler Pulley Adjustment Auger Belt Cable AdjustmentFrom Previous Auger Belt ReplacementRepair & Adjustments Service Performed Each Problem Probable Cause Corrective ActionMAINTENANCE/REPLACEMENT Parts USE HRS SeasonDisclaimer of Warranty Year Limited WarrantyInstruction No -1806 I.R /6/03