Auger Housing and Chute Group - 24, 28 & 32 inch
NOTE: Unless noted otherwise, | 987028 |
use the standard hardware torque specification chart.
Decal must cover gap at hinge pivot.
21 |
5 |
4 |
6 |
3 |
2 |
Plastic washer |
|
(Ref. 2) goes |
|
between chute | 1 |
and deflector. |
|
7 |
8 |
2511 |
124 |
13
14 |
19 |
22 |
17 |
18 |
16 |
41 |
9
15
Mount cable bracket (Ref. 22) on right hand side of handle using shift control bracket hardware.
Coat top and bottom of | 23 When installing cable, | |
make sure it does not | ||
chute ring with grease. |
42 |
40 |
39 |
10
27 |
38 |
come into contact with |
muffler. |
24 |
25 |
26 |
Scraper blade should be on inside of housing.
37 |
35 |
36 |
34
28 |
29 |
30 |
33 | 32 |
31 |
The above parts group applies to the following Mfg. Nos.:
1694847 | - 10560E | 1694867 | - 9560E |
1694848 | - 10560EX | 1694914 | - 9560EX |
1694849 | - 11570E |
|
|
1694850 | - E11570 |
|
|
1694851 | - 1380E |
|
|
1694852 | - E1380 |
|
|
© Copyright 2005 Simplicity Manufacturing, Inc. All Rights Reserved. | 24 | TP |