MTD 6DE manual Tire Pressure, Auger Control

Page 14

Tire Pressure

Before operating, check tire pressure and reduce pressure to between 15 psi and 20 psi.

NOTE: If the tire pressure is not equal in both tires, the unit may pull to one side or the other.

Auger Control

Refer to Auger Control Test on Page 11 to adjust the auger control.

Chute Assembly

 

The distance snow is thrown can be adjusted by

 

changing the angle of the chute assembly. To do so,

 

stop the engine by removing the ignition key and loosen

 

the plastic wing knob found on the left side of the chute

 

assembly. Pivot the chute upward or downward before

Figure 6

re-tightening the wing knob. See Figure 6.

 

14

Image 14
Contents Operator’s Manual Table of Contents Preparation Important Safe Operation PracticesTraining Maintenance & Storage OperationYour Responsibility Do not modify engineAssembling Your Snow Thrower Securing the HandleAttaching the Chute Assembly and Directional Control Tire PressureKnow Your Snow Thrower Auger Control Clean-Out ToolChute Assembly Drive ControlStarting The Engine Operating Your Snow ThrowerBefore Starting Gas & Oil Fill-Up Recoil StarterTo Engage Augers Stopping The EngineTo Engage Drive Auger Control TestDrift Cutters on models so equipped Chute Clean-Out ToolOperating Tips Drift Cutter KitMaking Adjustments Chute Bracket AdjustmentTire Pressure Shave Plate and Skid Shoes EngineLubrication Auger Belt Replacement Drive Belt Replacement Friction Wheel Removal OFF-SEASON Storage Trouble Shooting Guide Trouble Possible Causes Corrective ActionPage Parts List Styles C & D 457 48 57 Styles C & D Styles C & D 634-04144 13 x 634-04151 MANUFACTURER’S Limited Warranty for