SECTION 8: TROUBLESHOOTING
Problem |
| Possible Cause |
| Remedy |
|
|
|
|
|
Engine fails to start | 1. | Fuel tank empty, or stale fuel | 1. | Fill tank with fresh gasoline. |
| 2. | Blocked fuel line | 2. | Clean the fuel line. |
| 3. | Choke not ON | 3. | Turn Choke knob to ON position. |
| 4. | Faulty spark plug | 4. | Clean, adjust or replace spark plug. |
| 5. | Key not in ignition switch | 5. | Insert the key fully; do not turn. |
| 6. | Spark plug wire disconnected | 6. | Attach spark plug wire to the spark |
|
|
|
| plug on the engine. |
| 7. | Primer not used properly | 7. | Prime the engine as instructed earlier. |
|
|
|
| If the carburetor is flooded due to |
|
|
|
| |
Engine runs erratic | 1. | Unit running at FULL choke | 1. | Turn choke knob to OFF position. |
| 2. | Blocked fuel line or stale gasoline | 2. | Clean the fuel line, fill tank with fresh |
|
|
|
| gasoline. |
| 3. | Water or dirt in fuel system | 3. | Drain fuel tank and carburetor. Fill up |
|
|
|
| with fresh gasoline. |
Engine loses power | 1. | Spark plug wire loose | 1. | Connect spark plug wire. |
| 2. | Gas cap vent hole plugged | 2. | Remove ice and snow from gas cap. |
|
|
|
| Be certain that vent hole is clear. |
Excessive vibration | 1. | Loose parts or damaged auger | 1. | Stop the engine immediately and |
|
|
|
| disconnect spark plug wire. Tighten all |
|
|
|
| bolts and nuts. If vibration continues, |
|
|
|
| contact Sears service center. |
Unit fails to propel | 1. | Drive control cable not adjusted | 1. | Adjust drive control cable following |
itself |
|
|
| earlier instructions. |
| 2. | Drive belt loose or damaged | 2. | Replace drive belt. |
Unit fails to | 1. | Discharge chute clogged | 1. | Stop engine and disconnect spark |
discharge snow |
|
|
| plug wire. Clean discharge chute and |
|
|
|
| inside of auger housing. |
| 2. | Shear bolt sheared. | 2. | Replace shear bolt. |
| 3. | Foreign object lodged in auger | 3. | Stop engine immediately and |
|
|
|
| disconnect the spark plug wire. |
|
|
|
| Remove object from auger. |
| 4. | Auger control cable out of adjustment | 4. | Adjust auger control cable. |
| 5. | Auger belt loose or damaged | 5. | Replace auger belt. |
NOTE: For repairs beyond minor adjustments listed above, contact an authorized service dealer.
14