MTD 380 manual Knowing Your Snow Thrower

Page 7

SECTION 3: KNOWING YOUR SNOW THROWER

WARNING: Be familiar with all the controls on the snow thrower and their proper operation. Know how to stop the machine and disengage them quickly.

Compare Figure 5 with your equipment and follow description of controls, given below, to get familiar with their operation.

Auger Control Bail

Upper Handle

Starter Rope

Drive Control Bail

Gas Tank Cap

Discharge Chute

Shave

Plate

Chute Handle

Chute Knob

Chute Clean-Out Tool

Muffler

Starter Rope

 

 

Primer

Throttle Control

 

Choke Knob

 

Ignition Key

 

Auger

Skid Shoe

Figure 5

Throttle Control

The throttle control is located on the engine. It regulates the speed of the engine.

Drive Control Bail

Located on the underside of the upper handle, the drive control bail is used to engage/disengage wheels. Squeeze the drive control bail against the upper handle to engage the wheels; release to disengage.

Auger Control Bail

The auger control bail is adjacent to the upper handle. Squeeze this bail against the handle to engage the augers; release to disengage the augers.

WARNING: Never make adjustments to the discharge chute unless both auger and drive control bails are disengaged and the operator is standing beside the unit.

Chute Handle

The direction of snow throwing corresponds to the direction of the chute opening. Use the chute handle to turn the chute assembly in the right direction.

Chute Knob

The distance snow is thrown can be adjusted by raising the upper chute for greater distance, or lowering it for less distance. Loosen the chute knob on the side of the discharge chute to adjust. Pivot the chute to desired position, and retighten the chute knob.

Safety Ignition Switch

The ignition key is necessary for the engine to start. Insert key into the switch to start; do not turn it to start/ stop the unit. Remove key when the unit is not in use.

Skid Shoe

The space between the shave plate and the ground can be adjusted. For close snow removal, place skid shoes in the low position. Use middle or high position when area to be cleared is uneven.

7

Image 7
Contents MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio Operator’s ManualTable of Contents Operation Important Safe Operation PracticesTraining PreparationYour Responsibility Maintenance & StorageDo not modify engine Assembling Your Snow Thrower Skid Shoe Tire Pressure Pneumatic TiresDrive Cable Knowing Your Snow Thrower Recoil Starter Operating Your Snow ThrowerBefore Starting Engine To Start EngineElectric Starter if equipped Before StoppingTo Stop The Snow Thrower Clearing The SnowLubrication Cleaning The Discharge ChuteMaintaining Your Snow Thrower General RecommendationsShave Plate and Skid Shoes Service & AdjustmentEngine Check V-BeltsAuger Belt Replacing BeltsDrive Belt Auger Cable Making AdjustmentsOFF-SEASON Storage Servicing AugersProblem Possible Cause Remedy Troubleshooting1819 Ref. No Description Parts List for ModelModel Ref. No. Part No Description 41 48 47 48 Auger Housing Components MANUFACTURER’S Limited Warranty for